RJX Servo line Color Black & Green

Wanting to clean up the appearance of your helicopter, aircraft of RC vehicle & protect your servo lines from chaffing? Servo Line Covering is a simple method to protect your servo wires, including a clean, visual want to your RC maker, and can be installed in a matter of minutes. Choose from our amazing line of different colors to include a whole make over to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, measure the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal inside. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the suched as heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, thus giving you a flush, tight fit over the previously frayed servo covering. Do the very same with the end of your servo wire, being careful to leave the terminal bare so it can quickly connected into your receiver. Also, make certain to take note of the servo wire polarity if you cover the complete wire – this will ensure that you will know exactly what direction to plug your servo terminal into your receiver.

This is a amazing enhancement to the thing currently being gone over.

Servo line Color Black and Red

Wanting to clean up the appearance of your helicopter, aircraft of RC vehicle & protect your servo lines from chaffing? Servo Line Covering is a simple method to protect your servo wires, including a clean, visual want to your RC maker, and can be installed in a matter of minutes. Choose from our amazing line of different colors to include a whole make over to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, measure the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal inside. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the suched as heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, thus giving you a flush, tight fit over the previously frayed servo covering. Do the very same with the end of your servo wire, being careful to leave the terminal bare so it can quickly connected into your receiver. Also, make certain to take note of the servo wire polarity if you cover the complete wire – this will ensure that you will know exactly what direction to plug your servo terminal into your receiver.