RJX Servo Line - Black and Dark Blue (1m)

Aiming to clean up the appearance of your helicopter, airplane of RC cars and truck & protect your servo lines from chaffing? Servo Line Covering is an easy method to protect your servo wires, adding a clean, aesthetic aim to your RC maker, and can be set up in a matter of minutes. Select from our interesting line of diverse colors to include a whole new look to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and insert the servo terminal inside. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the included heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat weapon to diminish it down around the covering, hence giving you a flush, tight fit over the previously frayed servo covering. Do the very same with the end of your servo wire, being careful to leave the terminal bare so it can easily plug into your receiver. Likewise, make sure to remember of the servo wire polarity if you cover the complete wire – this will make sure that you will understand what direction to plug your servo terminal into your receiver.