RJX Servo line Color Blue/Black (1m)

Planning to clean up the look of your helicopter, plane of RC vehicle & protect your servo lines from chaffing? Servo Line Covering is a simple method to protect your servo wires, including a clean, aesthetic look to your RC device, and can be installed in a matter of minutes. Pick from our amazing line of different colors to include an entire make over to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply remove your servo(s) from the receiver, measure the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the consisted of heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat gun to diminish it down around the covering, thus providing you a flush, tight fit over the previously frayed servo covering. Do the same with completion of your servo wire, bewaring to leave the terminal bare so it can easily plug into your receiver. Also, make sure to take note of the servo wire polarity if you cover the full wire – this will guarantee that you will know exactly what direction to plug your servo terminal into your receiver.

Right here is a great thing that numerous others have actually bought at the very same time.

Servo line Color Black and Red

Planning to clean up the look of your helicopter, plane of RC vehicle & protect your servo lines from chaffing? Servo Line Covering is a simple method to protect your servo wires, including a clean, aesthetic look to your RC device, and can be installed in a matter of minutes. Pick from our amazing line of different colors to include an entire make over to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply remove your servo(s) from the receiver, measure the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the consisted of heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat gun to diminish it down around the covering, thus providing you a flush, tight fit over the previously frayed servo covering. Do the same with completion of your servo wire, bewaring to leave the terminal bare so it can easily plug into your receiver. Also, make sure to take note of the servo wire polarity if you cover the full wire – this will guarantee that you will know exactly what direction to plug your servo terminal into your receiver.