RJX Servo line Color Black and Red

Wanting to tidy up the appearance of your helicopter, plane of RC car & safeguard your servo lines from chaffing? Servo Line Covering is an easy method to safeguard your servo wires, including a clean, visual look to your RC device, and can be set up in a matter of minutes. Choose from our interesting line of diverse colors to include an entire makeover to your RC machine!

Included In Package:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the suched as heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat gun to diminish it down around the covering, therefore providing you a flush, tight fit over the previously frayed servo covering. Do the exact same with the end of your servo wire, taking care to leave the terminal bare so it can quickly connected into your receiver. Also, make sure to take note of the servo wire polarity if you cover the full wire - this will ensure that you will know exactly what instructions to plug your servo terminal into your receiver.

The listed below thing additionally sets truly well with the thing being gone over.

Servo line Color Black & Green

Wanting to tidy up the appearance of your helicopter, plane of RC car & safeguard your servo lines from chaffing? Servo Line Covering is an easy method to safeguard your servo wires, including a clean, visual look to your RC device, and can be set up in a matter of minutes. Choose from our interesting line of diverse colors to include an entire makeover to your RC machine!

Included In Package:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the suched as heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat gun to diminish it down around the covering, therefore providing you a flush, tight fit over the previously frayed servo covering. Do the exact same with the end of your servo wire, taking care to leave the terminal bare so it can quickly connected into your receiver. Also, make sure to take note of the servo wire polarity if you cover the full wire – this will ensure that you will know exactly what instructions to plug your servo terminal into your receiver.