Traxxas Yokes Diff/Tranny

These are the Diff and Trans Drive Yokes for the Traxxas T-Maxx 3.3. TRAC78**

FEATURES:
Black plastic building and construction

INCLUDES:
Two drive yokes
Two 4x15mm Yoke pins

REQUIRES:
T-Maxx 3.3

SPECS:
Length: 15/16" (23mm)
Size: 3/4" (17mm)

You will like this thing if you have the thing earlier stated.

Center Half Shafts E-Revo

This is the Center Half Shaft Set for the Traxxas E-Revo

FEATURES:
Plastic building and construction, black in color

INCLUDES:
Center half shafts (three internal splined and 2 external splined)

REQUIRES:
Installation on the automobile

SPECS:
Size: 17.2mm (0.68")

This product compliments the above discussed product.

Driveshaft Assembly (1)

This is the Driveshaft Assembly for the Traxxas Revo 3.3.
and the T-Maxx 3.3.

FEATURES:
Totally assembled
Plastic telescoping driveshaft with steel universals
Blue rubber boot shields telescoping sections from dirt
Attaches to the differential with one screw pin
Works on the front or back, right or left of automobile

INCLUDES:
#5458X Yoke, TRAC9798
#5145 Screw Pin, TRAC5145
#5450 Halfshaft, TRAC7450
#5452 U Joint, TRAC7452
#5459 Rubber Boot, TRAC7459
Direction sheet

REQUIRES:
Installing on chassis

This product compliments the above discussed product.

U-Joints, Driveshaft Revo

These are the Drive Shaft Joints for the Traxxas Revo.

FEATURES:
Steel universal joint set

INCLUDES:
Four Steel Universal obstructs
Four Steel Universal pins
Two black steel set pins
Four steel hinge pins
Four steel bearing pins
Eight 1.4mm e-clips

REQUIRES:
Installing on Traxxas Revo

Get this product to enhance the one you read around.

Bbs Blue Rubber Sealed 6 X 13M

This is a set of Traxxas 6x13x5mm Ball Bearings
for use on the E-Revo

FEATURES:
Stainless-steel bearing building and construction
Blue rubber dirt shields

INCLUDES:
(2) 6x13x5mm ball bearings Part #5180

SPECS:
Inside size: 6mm (0.24")
Outside size: 13mm (0.51")
Width: 5mm (0.20")

Want one more wonderful product to compliment the above pointed out product?

Pivot Ball Caps & Dust Boots

This is the replacement Pivot Ball and Dust Cap Boot Set
    for the Traxxas Revo, E-Revo and T-Maxx 3.3 vehicles.

FEATURES:
Nylon and Rubber Building and construction
Blue and Black in Color

INCLUDES:
Four Blue Rubber Pivot Ball Boots
Four Black Dust Boot Retainer
Four Blue Notched Dust Boot Retainer
Four Blue Rubber Boot Plugs
Four nylon Pivot Ball Retainers
Direction sheet

REQUIRES:
Two plans needed to finish truck

This product compliments the main item below.

12 X 18 X 4Mm Ball Bearing (2) Blue Rubber Sheild Revo

    These are the replacement Wheel Center Ball Bearings for
the Traxxas Nitro Revo Monster Truck.

FEATURES:
Stainless-steel Building and construction
Blue Rubber Sealed

INCLUDES:
Two 12mm x 18mm Blue Sealed Stainless Wheel Center Bearings

REQUIRES:
Assembly onto Vehicle

SPECS:
Outer Size: 18mm (0.70")
Inner Size: 12mm (0.47")
Density: 4mm (0.15")

REMARKS:
These are for the Within the Wheel Centers, the Truck Requires
Four Total of these Bearings.

Get this product to enhance the one you read around.

Stub Axle Yokes & Pins Revo

This is a set of replacement Drive Yokes for the Traxxas Revo.
These yokes connect to the half shaft assemblies.

FEATURES:
Black plastic building and construction

INCLUDES:
Two yokes
Two drive pins

REQUIRES:
Absolutely nothing. These are direct replacement parts.