Traxxas Bbs Blue Rubber Sealed 6 X 13M

This is a set of Traxxas 6x13x5mm Ball Bearings
for usage on the E-Revo

FUNCTIONS:
Stainless-steel bearing building
Blue rubber dirt guards

INCLUDES:
(2) 6x13x5mm ball bearings Part #5180

SPECIFICATIONS:
Inside diameter: 6mm (0.24")
Outside diameter: 13mm (0.51")
Width: 5mm (0.20")

Below is a terrific item that lots of others have purchased the very same time.

12 X 18 X 4Mm Ball Bearing (2) Blue Rubber Sheild Revo

    These are the replacement Wheel Hub Ball Bearings for
the Traxxas Nitro Revo Monster Truck.

FEATURES:
Stainless Steel Building and construction
Blue Rubber Sealed

INCLUDES:
2 12mm x 18mm Blue Sealed Stainless Wheel Hub Bearings

NEEDS:
Assembly onto Car

SPECIFICATIONS:
Outer Size: 18mm (0.70")
Inner Size: 12mm (0.47")
Density: 4mm (0.15")

REMARKS:
These are for the Inside of the Wheel Hubs, the Truck Needs
Four Total of these Bearings.

This item is regularly gotten with the above discussed item.

Driveshaft Assembly (1)

This is the Driveshaft Assembly for the Traxxas Revo 3.3.
and the T-Maxx 3.3.

FUNCTIONS:
Fully assembled
Plastic telescoping driveshaft with steel universals
Blue rubber boot guards telescoping sections from dirt
Connects to the differential with one screw pin
Works on the front or rear, right or left of automobile

INCLUDES:
#5458X Yoke, TRAC9798
#5145 Screw Pin, TRAC5145
#5450 Halfshaft, TRAC7450
#5452 U Joint, TRAC7452
#5459 Rubber Boot, TRAC7459
Guideline sheet

NEEDS:
Setting up on chassis

Below is an additional item that praises the item being gone over.

Axle Carriers Use Larger 6 X 1

These are the Optional Axle Carriers L & R for
usage on the Traxxas Revo series.

FEATURES:
Nylon Building and construction
Black in Color
Enables Oversized Bearing use

INCLUDES:
One Left Axle Provider
One Right Axle Provider
Four Dust Boot Retainers
2 Bearing Spacers

NEEDS:
Installation

This item praises the above gone over item.

5 X 11 X 4Mm Ball Bearing (2) Blue Rubber Shield R Evo

This is a 2 pack of 5X11mm Ball Bearings for the Traxxas Revo.

FEATURES:
Metal bearing building
Blue rubber dirt guards

INCLUDES:
(2) 5X11mm ball bearings, Part #5116

SPECIFICATIONS:
Inside diameter: 3/16" (5mm)
Outside diameter: 7/16" (11mm)
Width: 5/32" (4mm)

You will certainly enjoy this item if you have the item above mentioned.

Pivot Ball Caps & Dust Boots

This is the replacement Pivot Ball and Dust Cap Boot Set
    for the Traxxas Revo, E-Revo and T-Maxx 3.3 vehicles.

FEATURES:
Nylon and Rubber Building and construction
Blue and Black in Color

INCLUDES:
Four Blue Rubber Pivot Ball Boots
Four Black Dust Boot Retainer
Four Blue Notched Dust Boot Retainer
Four Blue Rubber Boot Plugs
Four nylon Pivot Ball Retainers
Guideline sheet

NEEDS:
2 plans needed to complete truck

This item praises the main item here.



This is the replacement Steering Block L&R for
usage with the Associated RC10GT2.

FEATURES:
Nylon Building and construction
Black in Color

INCLUDES:
One Left Steering Block
One Right Steering Block

NEEDS:
Installation

You will certainly enjoy this item if you have the item above mentioned.



This is the replacement 30 Degree Caster Block for the Group Associated
RC10GT2 Factory Team.
This will likewise work as a replacement for the 25 Degree Blocks - ASCC7919
that featured the RC10GT2 RTR

FUNCTIONS:
Composite nylon building, black in color
Replaces used or damaged caster blocks

INCLUDES:
2 30 degree caster blocks

NEEDS:
Installation following the design manual