Align T-Rex 150 DFC Combo BTF Twin BL Motor, 2S 7.4V 250Mah

Align's tiniest and most small 3D helicopter T-Rex 150 DFC, brings the same superior pedigree and design idea that stemmed from the effective T-Rex line of helicopters. Featuring strong power, superior flight control stability, and equipped with high end components, far exceeding any other helicopters currently on the market.

Twin brushless motor design, paired with 2s 7.4v 250mah battery, developing power that will surpass all your expectations. Metal DFC main rotor head assembly including high end visual and superior flight performance; in addition, an integrated control system with specifically enhanced 3-axis gyro, receiver, electronic speed controller, and 4g servos. All of these allow the T-Rex 150 DFC to posses the same stability, superior agility, and tail holding efficiency as the bigger helicopters.

T-Rex 150 functions built in Futaba S-FHSS 2.4Ghz system, and support making use of Spektrum DSM2/DSMX / JR DSM2/DSMJ/DMSS satellite receivers. To obtain the T-Rex 150 air-borne, everythings required is inputting of specifications noted in handbook into your transmitter, and binding of your transmitter.

Miniature size, control accuracy that appears like the bigger helicopters, enables you to delight in flying inside a restricted space. Novices can even enjoy this with ease by just turning down the speed dial. The innovative development T-Rex 150 will bring you a brand-new measurement of flying enjoyment.

Specification:
Length: 255mm
Height: 80mm
Main Blade Length: 120mm
Main Rotor Diameter: 271mm
Tail Rotor Diameter: 41mm
Motor Pinion Gear: 10T
Main Drive Gear: 78T
Drive Gear Ratio: 1:7.8
Weight (w/o Battery): 53g

Accessories:
T-REX 150 DFC Set x 1
Main Blades x 2set
Tail Blades x 1
150M Main Motor x 1
150M Tail Motor x 1
S150 micro Servo x 2
DS155 micro Servo x 1
Blnd Plug x 1
Remote Extension x 1
7.5V Li-Po 250mAh Li-Polymer Battery x 1

Radio transmitter and electronic equipment needed for assembly:
1.ALIGN T6 or Futaba S-FHSS 2.4G Transmitter or JR DSM2/DSMJ/DMSS、Spektrum DSM2/DSMX 2.4GHz Transmitter

Want an additional great thing to match the above mentioned thing?

2S1P 7.4V 250mAh/30C

Usage for T-REX 150.

Direction::
Max Constant Discharge: 30C. Regular operating temperature is approx. 40-65?C(within 80% of ranked discharge). Max. temperature: 80?C.
Recommend to release the battery within 80% of ranked discharge, keep 95% capability when over 100 cycles, keep 90% capability when over 150 cycles.(The cycle life and effectiveness will decrease due to high existing, high temperature and over-discharge)

KEEP IN MIND::
When utilizing high energy Li-poly Battery, please do not over-discharge, over-charge batteries, or result over-high temperature. Releasing capability cannot surpass 80% of the max capability after full charging to make sure a good cycle performance.Recommend to full charge a brand new battery prior to utilizing and only release the battery 50% for first 5 times to make a good effectiveness of the battery. Please make it a practice to constantly count time for flight, or please set a low voltage security on ESC (Cell voltage after stopping utilizing can not lower than 3.4V). Do not utilize the battery at insufficient of voltage.

Do not expose batteries to sunlight or shop/ charge batteries at the temperature approximately 35℃ in a airtight vehicle. The environment high temperature might cause the damage or the threat of burst. If the battery ends up being hot while high existing discharging or flying, please do not charge the battery right away. Wait to cool off(about 20 mins), then inspect to recharge. If versus follow the initial factory utilizing guidelines, possibly cause the battery to pump up or any hazardous mishap occurs.
Do not leave the battery charger is running ignored as it may cause a fire.

Specifications:
Output:7.4V250mAh (2S1P)
Measurement:47x21.5x12mm
Weight:15g