Align T-Rex 150 DFC Combo BTF Twin BL Motor, 2S 7.4V 250Mah

Align's tiniest and most petite 3D helicopter T-Rex 150 DFC, brings the exact same exceptional pedigree and design concept that stemmed from the effective T-Rex line of helicopters. Including strong power, exceptional flight control stability, and equipped with high end elements, far exceeding other helicopters currently on the market.

Twin brushless motor design, paired with 2s 7.4v 250mah battery, developing power that will exceed all your expectations. Metal DFC primary rotor head assembly including high end aesthetic and exceptional flight efficiency; in addition, an integrated control system with specifically optimized 3-axis gyro, receiver, electronic speed controller, and 4g servos. All these make it possible for the T-Rex 150 DFC to posses the exact same stability, exceptional dexterity, and tail holding effectiveness as the larger helicopters.

T-Rex 150 functions integrated in Futaba S-FHSS 2.4Ghz system, and support the use of Spektrum DSM2/DSMX / JR DSM2/DSMJ/DMSS satellite receivers. To obtain the T-Rex 150 air-borne, everythings required is inputting of parameters listed in manual into your transmitter, and binding of your transmitter.

Miniature size, control accuracy that appears like the larger helicopters, enables you to take pleasure in flying inside a confined space. Newbies can even enjoy this with ease by just turning down the speed dial. The innovative advancement T-Rex 150 will inspire you a brand-new dimension of flying enjoyment.

Specification:
Length: 255mm
Height: 80mm
Main Blade Length: 120mm
Main Rotor Size: 271mm
Tail Rotor Size: 41mm
Motor Pinion Gear: 10T
Main Drive Gear: 78T
Drive Gear Ratio: 1:7.8
Weight (w/o Battery): 53g

Accessories:
T-REX 150 DFC Set x 1
Main Blades x 2set
Tail Blades x 1
150M Main Motor x 1
150M Tail Motor x 1
S150 micro Servo x 2
DS155 micro Servo x 1
Blnd Plug x 1
Remote Extension x 1
7.5V Li-Po 250mAh Li-Polymer Battery x 1

Radio transmitter and electronic devices required for assembly:
1.ALIGN T6 or Futaba S-FHSS 2.4G Transmitter or JR DSM2/DSMJ/DMSS、Spektrum DSM2/DSMX 2.4GHz Transmitter

Want an additional fantastic item to match the above discussed item?

2S1P 7.4V 250mAh/30C

Use for T-REX 150.

Direction::
Max Continuous Discharge: 30C. Regular operating temperature is approx. 40-65?C(within 80% of ranked discharge). Max. temperature: 80?C.
Recommend to discharge the battery within 80% of ranked discharge, keep 95% capability when over 100 cycles, keep 90% capability when over 150 cycles.(The cycle life and effectiveness will decrease due to high existing, high temperature and over-discharge)

KEEP IN MIND::
When using high energy Li-poly Battery, please do not over-discharge, over-charge batteries, or result over-high temperature. Discharging capability can't exceed 80% of the max capability after full charging to make sure an excellent cycle performance.Recommend to full charge a brand name new battery before using and just discharge the battery 50% for first 5 times to make an excellent effectiveness of the battery. Please make it a routine to constantly count time for flight, or please set a low voltage defense on ESC (Cell voltage after stopping using can not reduce than 3.4V). Do not utilize the battery at inadequate of voltage.

Do not expose batteries to sunshine or store/ charge batteries at the temperature up to 35℃ in a airtight automobile. The environment high temperature might cause the damage or the danger of burst. If the battery ends up being hot while high existing discharging or flying, please do not charge the battery right away. Wait to cool off(about 20 minutes), then examine to charge. If against follow the original factory using rules, perhaps cause the battery to pump up or any hazardous mishap happens.
Do not leave the charger is running ignored as it may cause a fire.

Specifications:
Output:7.4V250mAh (2S1P)
Dimension:47x21.5x12mm
Weight:15g