Quantum Parallel 6 X JST-XH 2S Charge/Bal. Cable For Trex 150

Quantum Parallel 6 X JST-XH TWO Charge/Balance Cable For Trex 150 Q-CL-0040

Our parallel charge leads enable you to charge up to 6 battery packs concurrently. Constructed from the highest quality materials, they give you the very best connection possible every time you charge your batteries.

Specifications
Input Charge Connector: Male 4mm Banana Plug
Input Balance Connector: Male TWO JST-XH

Output Connector: TWO Female JST-XH
Wire Type: 24 AWG Silicone Charge Lead, 26 AWG Silicone Balance Lead
Existing Rating: 8A
Length: 4"

Often purchased with the thing that you are presently checking out.

2S1P 7.4V 250mAh/30C

Use for T-REX 150.

Direction::
Max Constant Discharge: 30C. Typical operating temperature level is approx. 40-65?C(within 80% of ranked discharge). Max. temperature level: 80?C.
Recommend to release the battery within 80% of ranked discharge, keep 95% capacity when over 100 cycles, keep 90% capacity when over 150 cycles.(The cycle life and effectiveness will reduce due to high existing, high temperature level and over-discharge)

NOTE::
When utilizing high energy Li-poly Battery, please do not over-discharge, over-charge batteries, or result over-high temperature level. Discharging capacity cannot surpass 80% of the max capacity after complete crediting ensure an excellent cycle performance.Recommend to complete charge a brand brand-new battery before utilizing and only release the battery 50% for very first 5 times to make an excellent effectiveness of the battery. Please make it a routine to always count time for flight, or please set a low voltage security on ESC (Cell voltage after stopping utilizing can not lower than 3.4V). Do not utilize the battery at inadequate of voltage.

Do not expose batteries to sunlight or shop/ charge batteries at the temperature level approximately 35℃ in a airtight vehicle. The environment high temperature level might trigger the damage or the danger of burst. If the battery becomes hot while high existing discharging or flying, please do not charge the battery right away. Wait to cool off(about 20 mins), then inspect to charge. If against follow the initial factory utilizing rules, perhaps trigger the battery to inflate or any harmful accident takes place.
Do not leave the charger is running unattended as it may trigger a fire.

Specifications:
Output:7.4V250mAh (2S1P)
Measurement:47x21.5x12mm
Weight:15g

Often purchased with the thing that you are presently checking out.

2S1P 7.4V 300mAh/30C

Use for T-REX 150.

Direction::
This Li-poly battery is utilizing series/balancing design, features high effective and high discharge.
Max Constant Discharge: 30C. Typical operating temperature level is approx. 40-65?C(within 80% of ranked discharge). Max. temperature level: 80?C.
Recommend to release the battery within 80% of ranked discharge, keep 95% capacity when over 100 cycles, keep 90% capacity when over 150 cycles.(The cycle life and effectiveness will reduce due to high existing, high temperature level and over-discharge)

NOTE::
When utilizing high energy Li-poly Battery, please do not over-discharge, over-charge batteries, or result over-high temperature level. Discharging capacity cannot surpass 80% of the max capacity after complete crediting ensure an excellent cycle performance.Recommend to complete charge a brand brand-new battery before utilizing and only release the battery 50% for very first 5 times to make an excellent effectiveness of the battery. Please make it a routine to always count time for flight, or please set a low voltage security on ESC (Cell voltage after stopping utilizing can not lower than 3.4V). Do not utilize the battery at inadequate of voltage.

Do not expose batteries to sunlight or shop/ charge batteries at the temperature level approximately 35℃ in a airtight vehicle. The environment high temperature level might trigger the damage or the danger of burst. If the battery becomes hot while high existing discharging or flying, please do not charge the battery right away. Wait to cool off(about 20 mins), then inspect to charge. If against follow the initial factory utilizing rules, perhaps trigger the battery to inflate or any harmful accident takes place.
Do not leave the charger is running unattended as it may trigger a fire.

Specifications:
Output:7.4V250mAh (2S1P)
Measurement:47x21.5x12mm
Weight:18g
Support 5C charging (Charging error might result in battery surge, fire, and other unforeseen danger or property loss. Please always charge batteries with equipment in sight, do not leave charger unattended. Need to you have to leave the charging area, please remove the battery and abort charging procedure.)