Align Feathering Shaft Wrench

Using on T-REX 550 / 600 / 700.

Requirements:
Feathering Shaft Wrench
(Φ8xΦ12x12mm,Φ10xΦ14x12mm) x 1

Several others have bought this product together with the product that you are currently reading about.

Feathering Shaft Wrench

Using on T-REX 450pro / 450sport / 500.

Requirements:
Feathering Shaft Wrench
(Φ4xΦ8x6mm,Φ6xΦ10x12mm) x 1

The listed below product likewise pairs actually well with the product being gone over.

Servo line Color Black and Red

Looking to clean up the look of your helicopter, plane of RC vehicle & secure your servo lines from chaffing? Servo Line Covering is an easy method to secure your servo wires, adding a clean, visual look to your RC machine, and can be set up in a matter of minutes. Select from our interesting line of different colors to include an entire make over to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply remove your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the included heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat gun to diminish it down around the covering, thus offering you a flush, tight fit over the formerly frayed servo covering. Do the very same with the end of your servo wire, bewaring to leave the terminal bare so it can quickly connected into your receiver. Also, make sure to keep in mind of the servo wire polarity if you cover the full wire – this will ensure that you will understand what instructions to plug your servo terminal into your receiver.

This is a fantastic enhancement to the product currently being gone over.

Swashplate Leveler

Use for T-REX 550/600/700/800 all class machine.

Requirements:
Swashplate unit corrector ? 1
Collar ? 1(Φ13.5xΦ10x20.5mm)
M3 Set screw ? 1(3x3mm)