Align Feathering Shaft Wrench

Utilizing on T-REX 550 / 600 / 700.

Requirements:
Feathering Shaft Wrench
(Φ8xΦ12x12mm,Φ10xΦ14x12mm) x 1

Numerous others have actually purchased this item along with the item that you are presently reading about.

Feathering Shaft Wrench

Utilizing on T-REX 450pro / 450sport / 500.

Requirements:
Feathering Shaft Wrench
(Φ4xΦ8x6mm,Φ6xΦ10x12mm) x 1

The listed below item also sets truly well with the item being reviewed.

Servo line Color Black and Red

Looking to tidy up the look of your helicopter, airplane of RC automobile & protect your servo lines from chaffing? Servo Line Covering is an easy way to protect your servo wires, adding a clean, visual seek to your RC machine, and can be set up in a matter of minutes. Select from our interesting line of varied colors to include an entire make over to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and insert the servo terminal inside. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the consisted of heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat gun to diminish it down around the covering, thus providing you a flush, tight fit over the formerly frayed servo covering. Do the exact same with completion of your servo wire, being careful to leave the terminal bare so it can quickly connected into your receiver. Also, make certain to take note of the servo wire polarity if you cover the complete wire – this will ensure that you will understand exactly what instructions to plug your servo terminal into your receiver.

This is a fantastic addition to the item presently being reviewed.

Swashplate Leveler

Usage for T-REX 550/600/700/800 all class machine.

Requirements:
Swashplate unit corrector ? 1
Collar ? 1(Φ13.5xΦ10x20.5mm)
M3 Set screw ? 1(3x3mm)