Align Swashplate Leveler

Use for T-REX 550/600/700/800 all class maker.

Requirements:
Swashplate system corrector ? 1
Collar ? 1(Φ13.5xΦ10x20.5mm)
M3 Set screw ? 1(3x3mm)

Get this item to boost the one you read about.

AP800 Digital Pitch Gauge

This is the Align AP800 Digital Pitch Gauge. Developed by Align's R&D team, the AP800 digital pitch gauge is ideal for flybar and flybarless helicopters and includes an auto-detecting Horizontal level, and the outcomes are displayed through a high contrast LCD screen, offering a simple and exact way to determine pitch angles.
Features:
Auto-detecting Horizontal level.
Utilizes backlighting LCD monitor.
Absolutely no and Lock function.
Noticeable pitch variety: -90? ~ 90?.
Automatic screen rotation.
Appropriate for 200~800mm main blades.
Build-in energy conserving function, power shuts down after 3 minutes without any movement.
Specifications:

Body Dimension: 108x53.9x16mm

Appropriate blade width: 20mm~74mm

Noticeable pitch variety: ?90?

Resolution: 0.1?

Battery: 2x CR 2032 Lithium

Weight: 38g (consisting of battery)

This item compliments the main item right here.

Servo line Color Black & Green

Planning to clean up the look of your helicopter, airplane of RC vehicle & protect your servo lines from chaffing? Servo Line Covering is a simple way to protect your servo wires, including a tidy, visual seek to your RC maker, and can be installed in a matter of minutes. Choose from our amazing line of diverse colors to include an entire make over to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply remove your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and place the servo terminal inside. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the included heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat weapon to diminish it down around the covering, hence offering you a flush, tight fit over the formerly frayed servo covering. Do the same with the end of your servo wire, bewaring to leave the terminal bare so it can easily connected into your receiver. Likewise, be sure to take note of the servo wire polarity if you cover the full wire – this will guarantee that you will know what direction to plug your servo terminal into your receiver.