Traxxas Ez Start Wiring Harness For Jato

This is the EZ Start Wire Harness
for the Traxxas Nitro Jato Arena Truck.

FEATURES:
Pre-Assembled Harness

CONSISTS OF:
One Harness w/Motor + and -, Ground Wire, Glow Plug Wire

NEEDS:
Assembly onto Car

Often gotten with the product that you are presently checking out.

Glow Plug S-Dty Long/Med

This is the Traxxas Super Task Long Glowplug.

FEATURES:
Suitable for all Traxxas engines including the 2.5, 2.5R and 3.3 engines
Suited for the varied throttle variety of off-road racing
Medium heat variety

CONSISTS OF:
One Traxxas Medium Heat Variety Super Task Long Glowplug with gasket

NEEDS:
Plug wrench (HCAP2550) for installing in cylinder head
Glow Fuel with 10%-20% nitro content

Lots of others have actually gotten this product in addition to the product that you are presently checking out.

5 X 11 X 4Mm Ball Bearing (2) Blue Rubber Shield R Evo

This is a 2 pack of 5X11mm Ball Bearings for the Traxxas Revo.

FEATURES:
Metal bearing construction
Blue rubber dirt shields

CONSISTS OF:
(2) 5X11mm ball bearings, Part #5116

SPECIFICATIONS:
Inside size: 3/16" (5mm)
Outdoors size: 7/16" (11mm)
Width: 5/32" (4mm)

The listed below product also pairs actually well with the product being discussed.

12 X 18 X 4Mm Ball Bearing (2) Blue Rubber Sheild Revo

    These are the replacement Wheel Center Ball Bearings for
the Traxxas Nitro Revo Beast Truck.

FEATURES:
Stainless Steel Building
Blue Rubber Sealed

CONSISTS OF:
Two 12mm x 18mm Blue Sealed Stainless Wheel Center Bearings

NEEDS:
Assembly onto Car

SPECIFICATIONS:
Outer Size: 18mm (0.70")
Inner Size: 12mm (0.47")
Density: 4mm (0.15")

COMMENTS:
These are for the Within the Wheel Hubs, the Truck Needs
Four Total of these Bearings.

This product compliments the main item below.

Bbs Blue Rubber Sealed 6 X 13M

This is a set of Traxxas 6x13x5mm Ball Bearings
for use on the E-Revo

FEATURES:
Stainless Steel bearing construction
Blue rubber dirt shields

CONSISTS OF:
(2) 6x13x5mm ball bearings Part #5180

SPECIFICATIONS:
Inside size: 6mm (0.24")
Outdoors size: 13mm (0.51")
Width: 5mm (0.20")

Here is one more product that compliments the product being discussed.



This is the replacement Steering Block L&R for
use with the Associated RC10GT2.

FEATURES:
Nylon Building
Black in Color

CONSISTS OF:
One Left Steering Block
One Right Steering Block

NEEDS:
Setup

Want one more terrific product to compliment the above mentioned product?



This is the replacement 30 Degree Caster Block for the Group Associated
RC10GT2 Factory Team.
This will likewise work as a replacement for the 25 Degree Blocks - ASCC7919
that come with the RC10GT2 RTR

FEATURES:
Composite nylon construction, black in color
Replaces worn or damaged caster blocks

CONSISTS OF:
Two 30 degree caster blocks

NEEDS:
Setup following the model manual