Traxxas Gearbox Halves (R&S)

These are the left and ideal gearbox halves for the Traxxas Rusler and Stampede
truck kits.

INCLUDES:
One left and one right gearbox half.

FEATURES:
Hard black nylon construction.

SPECS:
N/A--these will just deal with these 2 kits.

REQUIRES:
All the internal gears and shafts
Assembly

COMMENTS:
These do not consist of the hardware for assembly. Describe manual for
suitable screws.

2/12/97
AST

Right here is a excellent thing that numerous others have actually purchased the very same time.

5 X 11 X 4Mm Ball Bearing (2) Blue Rubber Shield R Evo

This is a 2 pack of 5X11mm Ball Bearings for the Traxxas Revo.

FEATURES:
Metal bearing building
Blue rubber dirt guards

CONSISTS OF:
(2) 5X11mm ball bearings, Part #5116

SPECS:
Inside size: 3/16" (5mm)
Externally size: 7/16" (11mm)
Width: 5/32" (4mm)

You will like this thing if you have the thing earlier mentioned.

Steel Top Drive Gear 22T

This is the 22 tooth, solidified steel top drive gear that fits a number of Traxxas
automobiles. .
Consists of: 1 gear just

You will like this thing if you have the thing earlier mentioned.

30T Idler Gear Steel

This is the optional Steel Idler Gear for numerous Traxxas Vehicles.

FEATURES:
Steel building

CONSISTS OF:
One steel 30T idler gear

REQUIRES:
Setup on automobile

Many others have actually gotten this thing along with the thing that you are currently reviewing.

Shaft Slipper Clutch

This is a Slipper Clutch Shaft for the Traxxas Rustler XL
and Stampede XL.

FEATURES:
Steel building
_
Roll pin pre-installed

CONSISTS OF:
One slipper clutch set

SPECS:
Length: 1.98" (50mm)
Size: .21" ( 5mm)

COMMENTS:
This part will fit both the standard and XL variation of the Rustler
or Stampede.