Traxxas Body Ultra Shock Xxl Grey (2)

These are the Shock Bodies for the Traxxas Ultra Shocks (TRAC3762)
used on the Traxxas T-Maxx 3.3.

FUNCTIONS:
Molded Composite
Gray in Color

INCLUDES:
(2) Bodies

REQUIRES:
Installation

SPECIFICATIONS:
Length: 1.777" (45.1mm)
Size: 0.521" (13.2mm)

Numerous others have actually acquired this thing along with the thing that you are currently reading about.

Gearbox Halves L&R Grey

This is a Left and Right Gearbox half with Idler Shaft for the
Traxxas Stampede and Traxxas Rustler.

FEATURES:
Gray plastic building
Steel idler shaft

INCLUDES:
One gearbox
One idler shaft

COMMENTS:
This part fit the requirement and XL variation of both the Stampede
and Rustler.

Below is an additional thing that praises the thing being discussed.

Plastic Shock Caps & Bottoms

These are Shock Caps and Bottoms for Traxxas kits.
These seal the shock containing the shock oil.

FEATURES:
Nylon building

INCLUDES:
2 nylon shock cap (tops)
2 nylon shock cap (bottoms)

REQUIRES:
Other shock parts

SPECIFICATIONS:
Size Tops Bottoms
16MM 13MM

COMMENTS:
These fit the N/E 4-tec, N/E Stampede, and T/E-Maxx

This thing praises the main item here.

Spring Retainers

These are the Traxxas Spring Retainers for Traxxas Shocks.
This set contains the spring retainers that hold the springs in
location over the shock body and the piston heads that manage the quantity
of oil circulation in the shock cylinder.

FEATURES:
Constructed of molded plastic.
Contains enough parts for two shocks.
Fits the shocks on the majority of Traxxas nitro and electric powered vehicles.
Two hole piston head for greater dampening or 3 hole piston head
    for softer spring performance.

INCLUDES:
One Traxxas Spring Retainer Set with:
    2 upper and two lower spring retainers
    2 2 hole piston head covers
    Two 3 hole piston head covers

REQUIRES:
Disassembly of shock to install parts.

The listed below thing likewise sets truly well with the thing being discussed.

Susp Screw Pin Set #2640 (Hex Drive)

These are the Suspension Screws Pins for the
Traxxas Rustler, Stampede and Bandit.
The hinge pins hold the suspension arms to the bulkheads

FUNCTIONS:
Durable steel building

INCLUDES:
2 48mm pins
2 34mm pins
2 30mm pins
2 28mm pins
2 25mm pins

REQUIRES:
Installation on the Rustler, Stampede or Bandit

COMMENTS:
For a complete suspension pin set order TRAC4940

This is a amazing addition to the thing currently being discussed.

Rear Bearing Carriers, For Traxxas Slash 2Wd, E-Rustler, E-Stamp

These are Optional Rear Bearing Carriers for the Traxxas Electric
Rustler, Stampede and Bandit.
The rear axles suit these bearing carriers.

FEATURES:
Black nylon building

INCLUDES:
2 rear bearing (hub) providers
2 RPM decals

REQUIRES:
(4) 5x11mm bearings, if required usage (2) DTXC1547.

SPECS:
Height: 40mm (1.58")
Width at largest point: 15.4mm (0.61")