RJX Servo line Color Black (1m)

Seeking to tidy up the look of your helicopter, airplane of RC car & safeguard your servo lines from chaffing? Servo Line Covering is a simple method to safeguard your servo wires, adding a clean, visual seek to your RC device, and can be installed in a matter of minutes. Pick from our amazing line of diverse colors to include an entire make over to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

This product compliments the above discussed product.

Servo line Color Green (1m)

Seeking to tidy up the look of your helicopter, airplane of RC car & safeguard your servo lines from chaffing? Servo Line Covering is a simple method to safeguard your servo wires, adding a clean, visual seek to your RC device, and can be installed in a matter of minutes. Pick from our amazing line of diverse colors to include an entire make over to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply remove your servo(s) from the receiver, measure the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the included heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat weapon to diminish it down around the covering, hence providing you a flush, tight fit over the formerly frayed servo covering. Do the exact same with the end of your servo wire, bewaring to leave the terminal bare so it can easily plug into your receiver. Also, make sure to take note of the servo wire polarity if you cover the full wire - this will make sure that you will understand what direction to plug your servo terminal into your receiver.

This product compliments the above discussed product.

Servo line Color Black and Red

Seeking to tidy up the look of your helicopter, airplane of RC car & safeguard your servo lines from chaffing? Servo Line Covering is a simple method to safeguard your servo wires, adding a clean, visual seek to your RC device, and can be installed in a matter of minutes. Pick from our amazing line of diverse colors to include an entire make over to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply remove your servo(s) from the receiver, measure the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the included heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat weapon to diminish it down around the covering, hence providing you a flush, tight fit over the formerly frayed servo covering. Do the exact same with the end of your servo wire, bewaring to leave the terminal bare so it can easily plug into your receiver. Also, make sure to take note of the servo wire polarity if you cover the full wire – this will make sure that you will understand what direction to plug your servo terminal into your receiver.