RJX Servo line Color Green (1m)

Planning to tidy up the appearance of your helicopter, airplane of RC car & protect your servo lines from chaffing? Servo Line Covering is an easy way to protect your servo wires, adding a clean, visual look to your RC device, and can be set up in a matter of minutes. Pick from our interesting line of diverse colors to add an entire new look to your RC machine!

Included In Package:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply remove your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal inside. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the consisted of heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat weapon to shrink it down around the covering, thus offering you a flush, tight fit over the previously frayed servo covering. Do the same with the end of your servo wire, being careful to leave the terminal bare so it can quickly connected into your receiver. Likewise, make certain to take note of the servo wire polarity if you cover the full wire - this will ensure that you will understand what direction to plug your servo terminal into your receiver.