RJX Servo line Color Green (1m)

Wanting to clean up the look of your helicopter, plane of RC vehicle & secure your servo lines from chaffing? Servo Line Covering is an easy method to secure your servo wires, including a clean, visual aim to your RC device, and can be set up in a matter of minutes. Choose from our amazing line of different colors to add a whole makeover to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply eliminate your servo(s) from the receiver, measure the length of covering you will need for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the included heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat weapon to diminish it down around the covering, thus providing you a flush, tight fit over the previously frayed servo covering. Do the same with completion of your servo wire, bewaring to leave the terminal bare so it can easily connected into your receiver. Also, make sure to remember of the servo wire polarity if you cover the complete wire - this will make sure that you will understand what instructions to plug your servo terminal into your receiver.