Traxxas Frt Axles (2) Bandit

This is a set of Front Axles for the Traxxas Outlaw Buggy Kit
and the Ready To Run version.

FEATURES:
Constructed of steel.

INCLUDES:
Two Front Axles for the Traxxas Outlaw Buggy Kit and Prepared to Run
    Variation with 2 0.14"(3.5mm) x 0.26"(7mm) plastic hex nuts.

SPECS:
Length: 0.94" (24mm)
Length of threaded area: 0.14" (3.5mm)
Thread size: 0.16" (4mm)

NEEDS:
Putting each axle into the Steering Blocks (TRAC9036), and setting up
    Stub Axle Pins (TRAC6754).

This product praises the above reviewed product.

Shaft Slipper Clutch

This is a Slipper Clutch Shaft for the Traxxas Rustler XL
and Stampede XL.

FEATURES:
Steel construction
_
Roll pin pre-installed

CONSISTS OF:
One slipper clutch set

SPECS:
Length: 1.98" (50mm)
Diameter: .21" ( 5mm)

COMMENTS:
This part will fit both the requirement and XL variation of the Rustler
or Stampede.

This is a wonderful addition to the product presently being reviewed.

Shock Rebuild Big Bore/Ultra

This is a shock reconstruct set for 2 Traxxas black plastic shocks. Consists of:

4 E-clips
2 C-clips
2 O-rings
8 Washers
2 Diaphrams

Below is an additional product that praises the product being reviewed.

30T Idler Gear Steel

This is the optional Steel Idler Gear for many Traxxas Vehicles.

FEATURES:
Steel construction

CONSISTS OF:
One steel 30T idler gear

NEEDS:
Setup on automobile