Traxxas Battery 6-Cell Nimh W/Molex (Fits Latrax 1/18 Models)

This is the Traxxas 6-Cell 1200mAH NiMH Battery with Molex Connector.

FEATURES:
Fits the 1/18 scale Traxxas Latrax Rally Car and other 1/18 scale
    automobiles
Shrinkwrapped
Wire lead and Molex connector

INCLUDES:
6-Cell 1200mAH NiMH Battery with Molex Connector

NEEDS:
NiMH suitable charger such as Duratrax Onyx 100, DTXP4190

SPECIFICATIONS:
Measurements: 1.3 x 0.51 x 3.6" (34 x 13 x 91mm)

COMMENTS:
Battery charger provided with the Latrax Rally vehicle is only for 5-cell
    usage.

The listed below item additionally pairs really well with the item being gone over.



This is the Electric Powered, 2.4GHz Radio Controlled, 1/18 scale
Ready-to-Run Latrax SST Arena Truck.

FEATURES:
Chassis: Molded composite nylon monocoque
Drive: 4 wheel shaft
Motor: 370 brushed
Radio: 2.4GHz handgun grip with electronic steering trim control
    water resistant 32 oz-in steering servo and 3-channel micro receiver
ESC: Waterproof, programmable with three driver profiles;
    Sport Mode, Race Mode and Training Mode
    Built-in two-stage low-voltage detection for LiPo batteries
Body: ProGraphix, cut and painted
Differentials: Gear type with steel ring and pinion gears
Battery: Traxxas Power Cell NiMH 6-cell stick pack w/Standard
    connector, quick release battery hold down
Battery Charger: DC powered 2amp peak detecting
Shocks: Oil-filled, adjustable
Front Suspension: Completely independent
Steering: Bellcrank type with servo saver
Tires: SST grippy, soft compound, aggressive tread pattern
Wheels: 5 spoke, 1.38" (35mm) external diameter
Bumpers: Front and rear flexible composite plastic

INCLUDES:
RTR Latrax SST Arena Truck with Brushed Motor, 2.4GHz Radio, ESC,
    NiMH Battery, Charger, 4 AA Batteries, Painted Body, Instructions

NEEDS:
Track and upkeep devices

SPECIFICATIONS:
Automobile;
Length: 12.16" (309mm)
Front and Rear Track: 6.73" (171mm) external edges of wheels measured
    side to side
Weight with Battery: 26.06oz (739g)
Weight without Battery: 20.16oz (572g)
Total Height: 4.61" (117mm)
Wheelbase: 6.44" (163.5mm)
Wheelbase: 6.44" (163.5mm)
Ground Clearance: 0.59" (15mm)
Internal Gear Ratio: 2.5:1
Total Drive Ratio: 15:1 (Stock, Out-of-box)
Gear Pitch: 0.5 Mod.
Front and Rear Shock Length: 2.36" (60mm)
Battery Tray Dimensions: 4.0 x 1.4 x 0.71" (102mm x 35mm x 18mm)
    Body;
Length: 12.2" (310mm)
Width: 6.8" (174mm)
Height: 3.7" (95mm)

COMMENTS:
Readily available in the following body colors;
    Blue, TRAD20BB 76044-1 1/18 LATRAX SS BLU #7 Keegan Kincaid
Edition
    Red, TRAD20RR 76044-1 1/18 LATRAX SS RED #74 Sheldon Creed
Edition

This item is regularly acquired with the above mentioned item.

Mini Body Clips (10)

This is a pack of ten optional mini body clips from Racers Edge.  These clips are intended for use with 1/18 scale automobiles.

This item is regularly acquired with the above mentioned item.



This is the Electric Powered, 2.4GHz Radio Controlled, 1/18 scale,
Ready to Run LaTrax Teton Beast Truck from Traxxas.

FEATURES:
Chassis: Molded composite nylon monocoque
Drive: 4 wheel, steel center driveshaft
Differentials: Solidified steel bevel gear
Radio: 2.4GHz with 2-channel micro receiver,
    water resistant guiding servo, and all weather condition electronic devices that allow
    driving through puddles, ice, slush, and more
Electronic Speed Control: Completely proportional forward, brake, reverse,
    programmbale with three drive profiles, Sport, Race and Training
    Mode, two-stage low-voltage detection for optional LiPo battery
Motor: 370 size brushed
Battery: 2/3A 6-cell, 7.2V, 1200mAh NiMH, with Standard connector
Battery Charger: 2A DC powered
Suspension: Completely independent
Shocks: Oil filled plastic body, coil over
Body: ProGraphix Completely painted with decals used
Steering: Two bellcranks on chassis to increase the speed of the
    servo, and provide exact geometry for the guiding angle of each
    wheel
Ball Bearings: Complete set consisted of
Front and Rear Bumpers: Plastic
Tires: Rubber, off-road tread
Wheels: 5 spoke 1.63" (41mm) diameter

INCLUDES:
RTR LaTrax Teton Beast Truck, with Motor, 2.4GHz Radio, ESC, NiMH
    Battery, Charger, 4 AA Batteries, User's manual, 10T Pinion
    Gear, 60T Spur Gear

SPECIFICATIONS:
Automobile;
Length: 10.16" (258mm)
Front Track: 4.17" (106mm)
Rear Track: 4.23" (107.5mm)
Weight: 19.2oz (55g) with battery
Weight: 13.3oz (43g) without battery
Height: 4.65" (118mm)
Wheelbase: 6.44" (163.5mm)
Shock Length: 2.36" (60mm)
Ground Clearance: 1.18" (30mm)
Internal Gear Ratio: 2.5:1
Total Drive Ratio: 15:1 stock
Battery Tray Dimensions: 4 x 1.4 x 0.71" (102 x 35 x 18mm)
    Body;
Length: 9.4" (239mm)
Width: 3.6" (91mm)
Height: 3.3" (84mm)

COMMENTS:
Readily available in the following body colors;
    Blue, TRAC50BB Orange, TRAC50NN
    Green, TRAC50GG Red, TRAC50RR

If replacement ball bearings are needed, Traxxas offers the
    7541X, Latrax Ball Bearing Set TRAC9804, that changes all the
    ball bearings.