Suppo Model 1400Kv Brushless Outrunner Motor, 3.17 MM Shaft, 3.5MM Bullet Co

Ideal for indoor 3D Flight, 220g and under, with 10A speed controller or little Multi-Rotor frames with Hobbywing 6A esc.

An outstanding motor for airplanes approximately 220 grams (8 oz) utilizing 2 li-poly cells. Very light-weight at 19 grams including integral prop saver for APC 8x3.8 SloFly or APC 8x4 E propeller and integral firewall install. Great for little 3D airplanes weighing around 6 oz, or aerobatic airplanes approximately 8 oz. Use with a 10 Amp brushless ESC and little 7.4V lithium batteries in the 400mah - 800mah range.

The motor includes a 3mm hardened steel shaft, dual ball bearings, integral prop saver for APC E props and integral firewall install flange. Keep in mind that the prop saver is sized for APC props. GWS props will need some adjustment to fit effectively. Countersunk mounting holes have 31mm spacing on centers.

Specifications
LI-Poly Cell:2-3
Ni-MH Cells: 6-10
RPM/V: 1400Kv
Max. performance current: 2-6 Amp
NoLoad current / 0.3 Amp
Present capacity: 7.5 A/60 s
Max. Performance: 74%
Weight with cables: 19g
Dimensions (mm): 27.6x11.5

Recomended model weight: 3D 220 g and under
Recomended prop without gearbox: 2xLi 8X4 - 3xLi 7X3.5

Right here is a fantastic thing that lots of others have bought at the same time.

Skywalker 15A V2 Esc

This thing is often bought with the above stated thing.

9x4.7 Slow Flyer Propeller

This is a 9x4.7 Slo-Flyer "tractor" (not a "pusher") aircraft propeller.
This prop produces a great deal of torque even at low speeds.

FEATURES:
Computer-optimized design gives these props a thinner profile and
    more "bite" with less noise.
Composite construction
Reinforcing carbon fibers assist preserve real, consistent pitch at
    any rpm.
Slo-Flyer propellers work well with Electric powered Park Flyer-type
    aircraft.

INCLUDES:
One carbon-reinforced nylon propeller
One set of little shaft locating rings
One locating ring instruction sheet

NEEDS:
ALL props need balancing (usage TOPQ5700)
May need prop reamer, usage GPMQ5005 (SAE) or GPMQ5007 (Metric)

SPECS:
Length: 9"
Pitch: 4.7

REMARKS:
Slo-Flyer props are Not designed for Radiance engines

This thing praises the main item below.

LIPO 860mAh 11.1V 35C

Pulse Batteries – Can You Feel the Power?

Pulse Ultra batteries bring a brand-new level of power to the RC scene, based upon cutting edge lithium polymer technology, and making the most of all the technological gains within this remarkable industry. Pulse is about power & efficiency at a cost that can be managed. No more does exceptional power come at a premium rate – Pulse provides it all in one pulse quickening punch.

Delivering extreme power for your RC applications, Pulse batteries provide everything you might imagine at a cost never seen. Adding to the addictive power of Pulse Ultra batteries is the 5C charge rate, allowing you to charge in quick succession, leaving previous 1C LiPo batteries back at the charger as you rip through the skies above.

Ranging from 35C, 45C, and mind blowing 65C discharge rates, Pulse has you covered in every method possible, delivering mind numbing power levels that will take your flight to an entirely brand-new level of extreme. If you're trying to find power, you just discovered it. Pulse provides extreme power for extreme pilots, and when it comes to value, Pulse merely cannot be beat.
Feel the pulse, and get hold of a brand-new Pulse Ultra Battery for your 3D needs!



Requirements:
Voltage: 11.1V
Cell Count: 3S
Capacity: 860mAh
Discharge Rate: 35C
Charge Rate:
Dimensions: 58mm x 31mm x 24.5mm (LxWxH)
Weight:
Balance Tap: JST-XH

Item Note:
Pulse batteries do not had power leads, and will need completion user to solder their own design of battery port for the battery to be effectively used. Pulse batteries come with bare leads covered with heat diminish protection, and are prepared for the port of choice to be soldered to the positive/negative leads.