Suppo Model 1400Kv Brushless Outrunner Motor, 3.17 MM Shaft, 3.5MM Bullet Co

Ideal for indoor 3D Flight, 220g and under, with 10A speed controller or small Multi-Rotor frames with Hobbywing 6A esc.

An exceptional motor for planes up to 220 grams (8 oz) using 2 li-poly cells. Really lightweight at 19 grams including integral prop saver for APC 8x3.8 SloFly or APC 8x4 E propeller and integral firewall program mount. Great for small 3D planes weighing around 6 oz, or aerobatic planes up to 8 oz. Use with a 10 Amp brushless ESC and small 7.4V lithium batteries in the 400mah - 800mah range.

The motor includes a 3mm solidified steel shaft, double ball bearings, integral prop saver for APC E props and integral firewall program mount flange. Note that the prop saver is sized for APC props. GWS props will require some adjustment to fit properly. Countersunk mounting holes have 31mm spacing on centers.

Specifications
LI-Poly Cell:2-3
Ni-MH Cells: 6-10
RPM/V: 1400Kv
Max. effectiveness existing: 2-6 Amp
NoLoad current / 0.3 Amp
Current capability: 7.5 A/60 s
Max. Effectiveness: 74%
Weight with cables: 19g
Measurements (mm): 27.6x11.5

Recomended model weight: 3D 220 g and under
Recomended prop without gearbox: 2xLi 8X4 - 3xLi 7X3.5

Below is a wonderful item that lots of others have purchased the same time.

Skywalker 15A V2 Esc

This item is frequently bought with the above mentioned item.

9x4.7 Slow Flyer Propeller

This is a 9x4.7 Slo-Flyer "tractor" (not a "pusher") plane propeller.
This prop produces a great deal of torque even at low speeds.

FEATURES:
Computer-optimized design offers these props a thinner profile and
    more "bite" with less noise.
Composite building and construction
Enhancing carbon fibers assist preserve true, consistent pitch at
    any rpm.
Slo-Flyer propellers work well with Electric powered Park Flyer-type
    aircraft.

INCLUDES:
One carbon-reinforced nylon propeller
One set of small shaft locating rings
One locating ring instruction sheet

NEEDS:
ALL props need balancing (usage TOPQ5700)
May need prop reamer, usage GPMQ5005 (SAE) or GPMQ5007 (Metric)

SPECIFICATIONS:
Length: 9"
Pitch: 4.7

REMARKS:
Slo-Flyer props are Not created for Glow engines

This item praises the main item right here.

LIPO 860mAh 11.1V 35C

Pulse Batteries – Can You Feel the Power?

Pulse Ultra batteries bring a brand-new level of power to the RC scene, based upon cutting edge lithium polymer technology, and benefiting from all the technological gains within this fantastic market. Pulse has to do with power & efficiency at an expense that can be managed. No longer does premium power come at a premium price – Pulse provides everything in one pulse quickening punch.

Delivering intense power for your RC applications, Pulse batteries provide everything you might imagine at a cost never ever seen. Adding to the addictive power of Pulse Ultra batteries is the 5C charge rate, permitting you to recharge in rapid succession, leaving previous 1C LiPo batteries back at the charger as you rip through the skies above.

Ranging from 35C, 45C, and mind blowing 65C discharge rates, Pulse has you covered in every method possible, providing mind numbing power levels that will take your flight to an entirely new level of extreme. If you're searching for power, you simply discovered it. Pulse provides intense power for intense pilots, and when it comes to value, Pulse simply can't be beat.
Feel the pulse, and get a brand-new Pulse Ultra Battery for your 3D demands!



Requirements:
Voltage: 11.1V
Cell Count: THREE
Capacity: 860mAh
Discharge Rate: 35C
Charge Rate:
Measurements: 58mm x 31mm x 24.5mm (LxWxH)
Weight:
Balance Tap: JST-XH

Item Note:
Pulse batteries do not featured power leads, and will need the end user to solder their own design of battery adapter for the battery to be properly utilized. Pulse batteries have bare leads covered with heat shrink security, and are ready for the adapter of choice to be soldered to the positive/negative leads.