RJX Servo line Color Blue/Black (1m)

Aiming to tidy up the appearance of your helicopter, plane of RC car & safeguard your servo lines from chaffing? Servo Line Covering is an easy way to safeguard your servo wires, adding a clean, aesthetic look to your RC device, and can be installed in a matter of minutes. Choose from our amazing line of varied colors to include an entire make over to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the consisted of heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat weapon to diminish it down around the covering, thus offering you a flush, tight fit over the previously frayed servo covering. Do the exact same with the end of your servo wire, bewaring to leave the terminal bare so it can easily plug into your receiver. Likewise, make certain to take note of the servo wire polarity if you cover the complete wire – this will make sure that you will know exactly what instructions to plug your servo terminal into your receiver.

Right here is a wonderful thing that lots of others have actually bought at the very same time.

Servo line Color Black and Red

Aiming to tidy up the appearance of your helicopter, plane of RC car & safeguard your servo lines from chaffing? Servo Line Covering is an easy way to safeguard your servo wires, adding a clean, aesthetic look to your RC device, and can be installed in a matter of minutes. Choose from our amazing line of varied colors to include an entire make over to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the consisted of heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat weapon to diminish it down around the covering, thus offering you a flush, tight fit over the previously frayed servo covering. Do the exact same with the end of your servo wire, bewaring to leave the terminal bare so it can easily plug into your receiver. Likewise, make certain to take note of the servo wire polarity if you cover the complete wire – this will make sure that you will know exactly what instructions to plug your servo terminal into your receiver.