RJX Servo line Color Black and Red

Looking to tidy up the appearance of your helicopter, aircraft of RC vehicle & secure your servo lines from chaffing? Servo Line Covering is an easy way to secure your servo wires, including a clean, aesthetic planning to your RC maker, and can be set up in a matter of minutes. Pick from our exciting line of different colors to include a whole makeover to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply eliminate your servo(s) from the receiver, measure the length of covering you will require for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the included heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, thus offering you a flush, tight fit over the previously frayed servo covering. Do the exact same with the end of your servo wire, being careful to leave the terminal bare so it can quickly connected into your receiver. Also, make sure to keep in mind of the servo wire polarity if you cover the complete wire - this will ensure that you will understand what instructions to plug your servo terminal into your receiver.

The listed below item additionally pairs actually well with the item being discussed.

Servo line Color Black & Green

Looking to tidy up the appearance of your helicopter, aircraft of RC vehicle & secure your servo lines from chaffing? Servo Line Covering is an easy way to secure your servo wires, including a clean, aesthetic planning to your RC maker, and can be set up in a matter of minutes. Pick from our exciting line of different colors to include a whole makeover to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply eliminate your servo(s) from the receiver, measure the length of covering you will require for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the included heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, thus offering you a flush, tight fit over the previously frayed servo covering. Do the exact same with the end of your servo wire, being careful to leave the terminal bare so it can quickly connected into your receiver. Also, make sure to keep in mind of the servo wire polarity if you cover the complete wire – this will ensure that you will understand what instructions to plug your servo terminal into your receiver.