Traxxas Gearbox Halves (R&S)

These are the left and best gearbox halves for the Traxxas Rusler and Stampede
truck kits.

INCLUDES:
One left and one right gearbox half.

FEATURES:
Difficult black nylon construction.

SPECS:
N/A--these will only deal with these two kits.

REQUIRES:
All the internal gears and shafts
Assembly

REMARKS:
These do not include the hardware for assembly. Refer to manual for
appropriate screws.

2/12/97
AST

Right here is a wonderful thing that several others have actually purchased the same time.

5 X 11 X 4Mm Ball Bearing (2) Blue Rubber Shield R Evo

This is a 2 pack of 5X11mm Ball Bearings for the Traxxas Revo.

FEATURES:
Metal bearing building
Blue rubber dirt guards

CONSISTS OF:
(2) 5X11mm ball bearings, Part #5116

SPECIFICATIONS:
Inside size: 3/16" (5mm)
Outside size: 7/16" (11mm)
Width: 5/32" (4mm)

You will certainly like this thing if you have the thing earlier discussed.

Steel Top Drive Gear 22T

This is the 22 tooth, hardened steel top drive gear that fits a number of Traxxas
cars. .
Includes: 1 gear only

You will certainly like this thing if you have the thing earlier discussed.

30T Idler Gear Steel

This is the optional Steel Idler Gear for numerous Traxxas Vehicles.

FEATURES:
Steel building

CONSISTS OF:
One steel 30T idler gear

REQUIRES:
Setup on car

Several others have actually bought this thing along with the thing that you are currently reviewing.

Shaft Slipper Clutch

This is a Slipper Clutch Shaft for the Traxxas Rustler XL
and Stampede XL.

FEATURES:
Steel building
_
Roll pin pre-installed

CONSISTS OF:
One slipper clutch set

SPECIFICATIONS:
Length: 1.98" (50mm)
Diameter: .21" ( 5mm)

REMARKS:
This part will fit both the requirement and XL version of the Rustler
or Stampede.