Great Planes Rimfire Prop Saver 28mm Motors

This is the ElectriFly Rimfire Prop Saver for use on 28mm Motors.

FEATURES:
Aluminum construction

INCLUDES:
One Prop Saver
Two Rubber O-Rings
Two Bushings

REQUIRES:
Setup on Rimfire 28mm Motor

Below is a fantastic product that numerous others have actually purchased the very same time.

Tower Pro SG90 Servo

Functions:
Micro Servo Titan 9g servo
Gear Type : All Nylon Gear
Dead Band Width : 2 usec
Stall Torque : 1.5kg/cm at 4.8V
Operation Voltage : 3.0 - 7.2Volts

Requirements:
Measurement : 23mm x 12mm x 29mm
Port Wire Length : About 248mm
Operating Speed : 0.12sec / 60 degrees (4.8V no load)
Temperature level Range : -30 to +60 Degree C
Net weight : about 11g
Color : black

Packing material:
1 x 9g TITAN Servo Sets (with devices)

This product praises the above talked about product.

930Kv Brushless Outrunner Motor, 3.17 MM Shaft, 3.5MM Bullet Con

LI-Poly Cell:2-3
Ni-MH Cells: 6-10
RPM/V: 1800Kv
Max. efficiency existing: 6-10 Amp
NoLoad current / 10 V: 0.8 Amp
Existing capacity: 16 A/60 s
Max. Efficiency: 74%
Shaft diameter: 3mm

A2208-12 just like: AXI 2208/20, E-Flite Park 370

This product praises the main item here.

6x4 Thin Electric Prop

This is a 6x4E Thin Composite propeller from Advanced Precision Composites.
For utilize on Electric powered aircraft just (not for radiance engines).

FEATURES:
Gray composite propeller blades that put together onto a propeller hub.
Comes with two adjuster rings that adapt to various motor shafts.
Comes in a bag connected to a header card.

INCLUDES:
One composite propeller
Two composite adapter rings
One instruction sheet

REQUIRES:
Assembly onto motor or gear drive device in your Electric plane.
Balancing

SPECS:
Diameter: 6"
Pitch: 4
Center inner diameter: 0.25"

REMARKS:
Usage Speed 400 Electric motors.

Below is a fantastic product that numerous others have actually purchased the very same time.

8x3.8 Slow Flyer Propeller

This is a 8x3.8 Slo-Flyer "tractor" (not a "pusher") airplane propeller.
This prop produces a lot of torque even at low speeds.

FEATURES:
Computer-optimized design offers these props a thinner profile and
    more "bite" with less noise.
Lightweight formed nylon construction reduces turning mass for
    higher output and longer life.
Reinforcing carbon fibers assist maintain real, constant pitch at
    any rpm.
Slo-Flyer propellers work well with Electric powered Park Flyer-type
    aircraft.

INCLUDES:
One carbon-reinforced nylon propeller
One set of little shaft locating rings
One locating ring instruction sheet

REQUIRES:
ALL props need balancing (use TOPQ5700)
May need prop reamer, use GPMQ5005 (SAE) or GPMQ5007 (Metric)

SPECS:
Length: 8"
Pitch: 3.8

REMARKS:
Slo-Flyer props are Not developed for Radiance engines

Below is an additional product that praises the product being talked about.

7x6E Thin Electric

This is a 7x6EP Thin Propeller from Advanced Precision Composites.
For utilize on electrical powered aircraft just (not for radiance engines).

FEATURES:
Gray composite construction
Has two adjuster rings that adapt to various motor shafts

INCLUDES:
One 7x6EP Thin Electric Propeller

REQUIRES:
ALL props need balancing, this is EXTREMELY essential, utilize TOPQ5700.
May requirement prop reamer, use GPMQ5005 (SAE) or GPMQ5007 (Metric)

SPECS:
Diameter: 7"
Pitch: 6
Center inner diameter: 0.25" (6.3mm)