Axial Aluminum Servo Horn 25T

This is the Axial 25T Aluminum Servo Horn for Futaba, Axial and Savox Servos.

FEATURES:
Tough anodized aluminum building and construction
Compression install, two screws install on either side of arm and
    tighten up center hole around servo spline

CONSISTS OF:
Axial 25T Aluminum Servo Horn
2 2x8mm socket head screws

SPECS:
Length: 0.98" (25mm) from center of servo mounting hole to end of arm
Hole Diameter: 3mm
Pitch:3x30

Several others have bought this product in addition to the product that you are presently reviewing.



The SW0231MG is a budget friendly water resistant digital servo with fantastic torque for lots of applications. This brushed servo features a speed of .17 and 208.0 oz-in of torque 6.0V. It combines leading edge innovation with super high 12-bit (4096) resolution and metal equipments for your higher accuracy when evading puddles. This is an excellent upgrade if your aiming to drive your RC automobile in any condition...rain, sleet, or snow.

Functions:

• Integrates cutting edge
  innovation with super high 12 bit (4096) resolution and metal gears.
• Waterproof.
• Brushed motor
• Extremely strong metal equipments ensure long-life and durability.
• Our servos are totally green ? from materials to production, these servos are ecologically friendly.
• Ideal for RC automobiles, trucks, buggies, and boats.

Dimensions(mm): 41.8x20.2x42.9
Weight(g): 66
Speed(@6.0V sec/60): .17
Torque(@6.0V oz-in): 208.0
Gear: Metal
Bearing: 2BB
Case: Plastic
25 Tooth Spline
IP Rating: 67
Frequency: 200-250hz
Pulse Width Frequency: 1520

Here is a fantastic product that numerous others have purchased the same time.



Racers Edge 25C 5000 mAh 2S1P LI-Poly Battery hardwired with Deans Ultra Plug. Racers Edge battery is lighter than conventional Ni-Cd or Ni-Mh batteries while providing enhanced performance and run times. It utilizes the same balancing connection as Align or Electrifly battery chargers. Make certain to use a voltage cut off if your speed control doesn't come geared up with one. ONLY USE A BATTERY CHARGER SPECIFICALLY FOR Li-Poly cells!!!

The listed below product additionally sets actually well with the product being talked about.

Steering Upgrade Kit

This is the Steering Upgrade Set by Axial
for usage on Axial AX10 and SCX10.

FEATURES:
Changes the stock plastic guiding links
This kit will increase guiding strength and accuracy

CONSISTS OF:
Plastic linkage set
2 aluminum linkage rods
Mounting hardware
In-depth instructions

REQUIRES:
Setup on model

This product compliments the main item right here.



This is a low-resistance, compact-size 2-Pin Ultra Plug Connector from Deans.
This design removes the possiblility of reverse polarity connections.
Provides a protected connection for battery and motor connections on R/C vehicles.

INCLUDES:
One 2-Pin Male Ultra Plug WSDM1302
One 2-Pin Female Ultra Plug WSDM1303

REQUIRES:
Soldering connectors onto wires

You will enjoy this thing if you have the thing just above stated.

Rock Crawler Brushed Motor 35T HD

This is the Tekin T35 HD 35 Turn Rock Spider Brushed Motor.

FEATURES:
High-strength updated ferrite magnets
Legal for rock crawling competitions
Entirely rebuildable
Dual accuracy ball bearings
120 day limited service warranty

CONSISTS OF:
Tekin T35 HD 35 Turn Rock Spider Brushed Motor

REQUIRES:
ESC such as the Tekin FXR Brushed ESC, TEKM1091
Motor leads
Pinion gear depending upon automobile

SPECS:
Input Voltage: 3S LiPo or 10-cell NiMH battery
Dimensions: 2.07 x 1.42" (52.7 x 36mm)
Shaft Diameter: 0.125" (3.2mm)
Bearing Size: 3/8 x 1/8"
Motor Weight: 5.98oz (169g)