Align 470L Tail Belt Feathering Shaft

Use for T-REX 470L

Tail Rotor Shaft Assembly(F12.5x48.5mm/15T) x 2

This item is frequently purchased with the above stated item.

Servo line Color Black & Green

Aiming to clean up the appearance of your helicopter, plane of RC cars and truck & protect your servo lines from chaffing? Servo Line Covering is a simple way to protect your servo wires, including a tidy, visual planning to your RC maker, and can be set up in a matter of minutes. Pick from our amazing line of diverse colors to include a whole make over to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the consisted of heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat gun to diminish it down around the covering, hence giving you a flush, tight fit over the formerly frayed servo covering. Do the very same with the end of your servo wire, being careful to leave the terminal bare so it can easily plug into your receiver. Also, make certain to take note of the servo wire polarity if you cover the complete wire – this will guarantee that you will know what direction to plug your servo terminal into your receiver.