Traxxas Stub Axles Rear (2)

These are the Rear Stub Axles
for the Traxxas Outlaw, Stampede and Rustler.

FEATURES:
Metal building, black and silver in color

INCLUDES:
2 rear stub axles and pins

SPECS:
Length: 1.65" (42mm)
Diameter: .51" (13mm) at largest point

Here is an additional item that praises the item being discussed.

Half Shafts Long Truck (2)

This is a set of telescoping drive shafts for heaven Eagle LS II.

Includes: 2 white nylon telescoping shaft (each shaft is made from two pieces)
4 aluminum U-joints

pcd 01/23/94

Here is an additional item that praises the item being discussed.

Half Shafts Long Truck (6)

This is a set of the Traxxas telescoping drive shafts (equivalent of dogbones
or swing shafts). These are for usage on Traxxas trucks.

Features: White plastic parts

Includes:
(6) sets of drive shafts (each set consists of an inside shaft wich
slides in the outside shaft).

Dimensions: 2.5" long when fully compressed.

Requires: Absolutely nothing else needed

This item is frequently gotten with the above stated item.

5 X 11 X 4Mm Ball Bearing (2) Blue Rubber Shield R Evo

This is a 2 pack of 5X11mm Ball Bearings for the Traxxas Revo.

FEATURES:
Metal bearing building
Blue rubber dirt guards

INCLUDES:
(2) 5X11mm ball bearings, Part #5116

SPECS:
Inside size: 3/16" (5mm)
Outdoors size: 7/16" (11mm)
Width: 5/32" (4mm)

Here is a wonderful item that several others have purchased the same time.

Caster Blocks, For Traxxas Electric Slash, Stampede, Rustler, Ni

These are RPM 30° Front Caster Blocks for the Traxxas
Electric Stampede and Rustler.
These obstructs install to the front A-arms and is what the
steering knuckles attach to.

FEATURES:
Nylon building, black in color
Stamped right and delegated guarantee right setup

INCLUDES:
2 RPM 30° Front Caster Blocks

NEEDS:
Assembly between A-arms and steering knuckles

The below item additionally pairs truly well with the item being discussed.



This is the ST Racing Silver Aluminum Back Hub Provider
for the Traxxas Slash 2WD, Stampede, Rustler and Bandit.

FEATURES:
Silver in color

INCLUDES:
One Silver Aluminum Back Hub Provider

Here is a wonderful item that several others have purchased the same time.

Plastic Shock Caps & Bottoms

These are Shock Caps and Bottoms for Traxxas kits.
These seal the shock including the shock oil.

FEATURES:
Nylon building

INCLUDES:
2 nylon shock cap (tops)
2 nylon shock cap (bottoms)

NEEDS:
Other shock elements

SPECS:
Diameter Tops Bottoms
16MM 13MM

COMMENTS:
These fit the N/E 4-tec, N/E Stampede, and T/E-Maxx

Lots of others have gotten this item in addition to the item that you are currently reading about.

Stub Axle Carriers (2) (R & S)

This is the Traxxas #3652 Stub Axle Provider that comes included with
the Rustler and Stampede trucks.

FEATURES:
Made from a black plastic/nylon material.
Also called the rear center or center carrier.
Has 2 possible install places for the outer hinge pin shaft.

INCLUDES.
2 Stub alxe carriers.

COMMENTS:
This holds the two 5x8mm bushings (or bearings) on the stub
axle likewise called the wheel shaft.

AXY
3/25/95

Here is a wonderful item that several others have purchased the same time.

Diff Output Yokes Bk (2) W/3X5mm Cntrsnk Screws (2 ) &

These are the Differential Output Yokes
for the Traxxas Outlaw, Stampede and Rustler VXL.

FEATURES:
Black plastic building

INCLUDES:
2 differntial output yokes
2 3x5mm countersunk screws
2 screw pins

NEEDS:
Installation

SPECS:
Length: .70" (18mm)
Diameter: .51" (13mm)