Traxxas Gearbox Halves (R&S)

These are the left and ideal gearbox halves for the Traxxas Rusler and Stampede
truck kits.

INCLUDES:
One left and one right gearbox half.

FEATURES:
Hard black nylon construction.

SPECS:
N/A--these will just deal with these two kits.

REQUIRES:
All the internal gears and shafts
Assembly

REMARKS:
These do not consist of the hardware for assembly. Refer to manual for
appropriate screws.

2/12/97
AST

Below is a excellent thing that several others have purchased the same time.

5 X 11 X 4Mm Ball Bearing (2) Blue Rubber Shield R Evo

This is a 2 pack of 5X11mm Ball Bearings for the Traxxas Revo.

FEATURES:
Metal bearing building and construction
Blue rubber dirt shields

CONSISTS OF:
(2) 5X11mm ball bearings, Part #5116

SPECIFICATIONS:
Inside diameter: 3/16" (5mm)
Outdoors diameter: 7/16" (11mm)
Width: 5/32" (4mm)

You will certainly like this thing if you have the thing above mentioned.

Steel Top Drive Gear 22T

This is the 22 tooth, solidified steel leading drive gear that fits numerous Traxxas
vehicles. .
Consists of: 1 gear just

You will certainly like this thing if you have the thing above mentioned.

30T Idler Gear Steel

This is the optional Steel Idler Gear for numerous Traxxas Vehicles.

FEATURES:
Steel building and construction

CONSISTS OF:
One steel 30T idler gear

REQUIRES:
Setup on automobile

Numerous others have purchased this thing along with the thing that you are currently reviewing.

Shaft Slipper Clutch

This is a Slipper Clutch Shaft for the Traxxas Rustler XL
and Stampede XL.

FEATURES:
Steel building and construction
_
Roll pin pre-installed

CONSISTS OF:
One slipper clutch set

SPECIFICATIONS:
Length: 1.98" (50mm)
Diameter: .21" ( 5mm)

REMARKS:
This part will fit both the requirement and XL version of the Rustler
or Stampede.