Traxxas Body Ultra Shock Xxl Grey (2)

These are the Shock Bodies for the Traxxas Ultra Shocks (TRAC3762)
used on the Traxxas T-Maxx 3.3.

FEATURES:
Molded Composite
Gray in Color

CONSISTS OF:
(2) Bodies

REQUIRES:
Setup

SPECS:
Length: 1.777" (45.1mm)
Diameter: 0.521" (13.2mm)

Several others have actually purchased this thing together with the thing that you are presently reviewing.

Gearbox Halves L&R Grey

This is a Left and Right Gearbox half with Idler Shaft for the
Traxxas Stampede and Traxxas Rustler.

FEATURES:
Gray plastic building
Steel idler shaft

CONSISTS OF:
One gearbox
One idler shaft

COMMENTS:
This part fit the requirement and XL version of both the Stampede
and Rustler.

Right here is one more thing that compliments the thing being gone over.

Plastic Shock Caps & Bottoms

These are Shock Caps and Bottoms for Traxxas kits.
These seal the shock containing the shock oil.

FEATURES:
Nylon building

CONSISTS OF:
2 nylon shock cap (tops)
2 nylon shock cap (bottoms)

REQUIRES:
Other shock elements

SPECS:
Diameter Tops Bottoms
16MM 13MM

COMMENTS:
These fit the N/E 4-tec, N/E Stampede, and T/E-Maxx

This thing compliments the main item right here.

Spring Retainers

These are the Traxxas Spring Retainers for Traxxas Shocks.
This set contains the spring retainers that hold the springs in
place over the shock body and the piston heads that control the amount
of oil circulation in the shock cylinder.

FEATURES:
Constructed of molded plastic.
Contains enough parts for two shocks.
Fits the shocks on many Traxxas nitro and electric powered vehicles.
Two hole piston head for greater dampening or 3 hole piston head
    for softer spring performance.

INCLUDES:
One Traxxas Spring Retainer Set with:
    2 upper and two lower spring retainers
    2 2 hole piston head covers
    Two 3 hole piston head covers

REQUIRES:
Disassembly of shock to set up parts.

The listed below thing also sets actually well with the thing being gone over.

Susp Screw Pin Set #2640 (Hex Drive)

These are the Suspension Screws Pins for the
Traxxas Rustler, Stampede and Bandit.
The hinge pins hold the suspension arms to the bulkheads

FEATURES:
Durable steel building

CONSISTS OF:
2 48mm pins
2 34mm pins
2 30mm pins
2 28mm pins
2 25mm pins

REQUIRES:
Setup on the Rustler, Stampede or Outlaw

COMMENTS:
For a total suspension pin set order TRAC4940

This is a superb enhancement to the thing presently being gone over.

Rear Bearing Carriers, For Traxxas Slash 2Wd, E-Rustler, E-Stamp

These are Optional Rear Bearing Carriers for the Traxxas Electric
Rustler, Stampede and Bandit.
The rear axles fit into these bearing carriers.

FEATURES:
Black nylon building

CONSISTS OF:
2 rear bearing (center) carriers
2 RPM decals

REQUIRES:
(4) 5x11mm bearings, if required usage (2) DTXC1547.

SPECS:
Height: 40mm (1.58")
Width at largest point: 15.4mm (0.61")