Traxxas Aluminum Tuned Pipe/Header Blue

This is an Aluminum Tuned Pipeline and Header Assembly.
For any cars and truck with a side exhaust and sideways mounted .12-.15 size engine.

FEATURES:
Blue anodized aluminum manifold, tuned pipe and pressure fitting.
Header twists around the back of the engine, angling downward at
    30 degrees, and levels off straight. This would point the tuned
    pipe toward the front of the model.
Allows the engine to have strong power across mid & upper RPM range.
Will twist around a lot of pull starter assemblies.

INCLUDES:
One Header (manifold)
One Tuned Pipeline w/ 90 degree pressure fitting set up
One White Silicone Coupler
Two Black Tie Straps (for the coupler)
One piece of blue basic size Fuel Tubing (for fuel tank pressure)
One Exhaust Gasket
Two 3 x 23mm cap head Screws (for mounting header to engine)
Two 3mm lock Washers (for mounting header to engine)
One 3" Installing Wire (for protecting pipe to the chassis) _
One 4 x 4mm Set Screw (for protecting wire to the pipe)
One 3 x 10mm flat head Screw (for protecting pipe to the chassis)
One 3mm nylon Nut (for protecting pipe to the chassis)

REQUIRES:
Putting together onto a .12 to .15 size engine and chassis.
2mm and 2.5mm hex driver and 5.5mm nut driver.

SPECS:
Pipeline Length: 114.6mm
Size: 32.1mm
Header mounting holes on center: 27.5mm