Traxxas 5000Mah 11.1V 3S 25C Ml Lipo

This is the Traxxas Power Cell 11.1V 5000mAh 25C THREE LiPo Battery.

FEATURES:
Semi stiff construction does not need a difficult case and gets rid of
    wire harness ports that can loosen up and fail
Engineered specifically to fit Traxxas models
New high existing port with gold-plated copper terminals and
    incorporated balance port
iD Auto Battery Identification allows Traxxas iD equipped battery chargers to
    automatically set and optimize charge settings for specific battery
MAXX cable television high-efficiency 12 gauge silicone jacketed wire

INCLUDES:
Traxxas Power Cell 11.1V 5000mAh 25C LiPo THREE Battery with High
    Existing Connector and Integrated Balance Plug

NEEDS:
LiPo suitable charger such as the Traxxas EZ-Peak Plus, TRAP2970
LiPo charging bag

SPECIFICATIONS:
Setup: 3S1P
Continuous Discharge: 25C (125A)
Max Burst Rate: 50C (250A)
Watt Hours: 55.5
Charge Rate: 1C (5A)
Max Charge Rate: 2C (10A)
Dimensions: 6.1 x 1.02 x 1.7" (155 x 26 x 44mm)
Weight: 13.3oz (376g)

COMMENTS:
ALWAYS use a LiPo-approved Charger
ALWAYS use a LiPo Cell Balancer
NEVER Charge over 4.20V per cell
NEVER Charge at currents greater than 1C
NEVER Trickle Charge
NEVER enable to Discharge listed below 2.5V per cell
NEVER disassemble or modify pack wiring in any way or puncture cells
NEVER place on combustible materials or leave ignored during
    charging
ALWAYS Charge in a fire-resistant area
ALWAYS set charger's output volts to match battery volts
CONSTANTLY shut out of reach of kids

Below is another thing that compliments the thing being reviewed.

Ez-Peak Plus Plus 100 Watt Nimh/Lipo Dual Charger W/ Id System

This is the Air Conditioner Powered Traxxas EZ-Peak 100W Dual Battery Charger
with iD Auto Battery Identification.

FEATURES:
Charges TWO and THREE LiPo batteries
5-8 cell NiMH batteries
Traxxas's iD innovation automatically sets up and optimizes charge
    settings for Traxxas iD equipped batteries
Charges 2 batteries simultaneously at approximately 50W (4 amps) each, or
    charges single battery at 100W (8 amp) output in High-Output
    mode
Charges a NiMH and LiPo at the very same time
Advanced Mode for full manual control of charger settings
Progress bar and audible notifies
Storage Mode prepares LiPo batteries for extended storage
1 Month limited service warranty through Traxxas beginning at date of
    purchase

INCLUDES:
Traxxas EZ-Peak 100W Dual Battery Charger with Air Conditioner Power Cable,
    Guidelines, Cooling Fan

SPECIFICATIONS:
Input Power: 100-240V/50-60Hz
Output: 100W max
Charge Current: 1-4A (double mode), 5-8A (high output mode)
Discharge Current Range: 500mA
Existing Drain for Balance Ports: 500mA
Weight: 20.3oz (575g)
Dimensions: 7 x 5.4 x 2.2" (176 x 138 x 57mm)

This thing is frequently purchased with the above mentioned thing.



This is the 2.4GHz Radio Controlled, Brushless Electric Powered,
Ready to Run Traxxas X-Maxx.

Innovative New Characteristic Include;

**Special Self-Righting Action, if car rolls upside down**
**just press a button on the transmitter and in most cases**
**the X-Maxx will flip upright onto its wheels.**

**One handed body install and elimination system**
**gets rid of body posts and pins.**

**Battery Retention System gets rid of body clips or hook and loop straps**

**Shock towers also function as bring handles and level supports**
    **when car is put upside down for upkeep.**

**Added Technical Information Will Be Included When It Appears.**

FEATURES:
Traxxas Stability Management (TSM): Superior tuning algorithms run on
    high-speed electronic elements to manage wheel spin and steering
    instructions on loose dirt, concrete and even ice and snow. TSM can be
    fine tuned or turned off by changing the multi-function knob on
    the TQi transmitter or the slider in the Traxxas Link app
Chassis: Composite nylon tub, modular design supplies easy access
    to crucial elements, lower front and rear skids and incorporated
    nerf bars for front, rear and side effect defense
Drive Four wheel shaft drive, high-strength steel CV driveshafts with
    splined wheel hexes that remove axle pins, aluminum splined
    center driveshaft
Brushless Motor: Velineon 1600, 4 pole 1600Kv, 5mm shaft, aluminum
    heat sink
Motor Mount: Cradle design gets rid of flexing, keyed pins lock gear
    mesh in location
Radio: 2.4GHz TQi transmitter with 5-ch micro TSM telemetry ready
    receiver, BEC voltage and motor temperature level sensors installed,
    self righting button, integrated fail safe,
    can be equipped with the TQi Docking Base along with the iPhone,
    iPad or iPod touch* to produce a visual user interface for the
    car Traxxas Link TQi Wireless Module required (not suched as)
Guiding Servo: High-torque with aluminum heat sink, double shear
    bearing supported servo horn
Electronic Speed Control: Velineon VXL-6s 6S LiPo suitable
Transmission; Single speed
Differentials: Sealed hardened steel bevel, oil filled, limited slip
Slipper Clutch: Dual fan cooled
Battery Retention System: Integrated into chassis leading brace for
    greater rigidness, gets rid of body clips or hook and loop straps,
    adjustable for different batteries
Body: ProGraphix painted and cut
Body Mount System: Quick one-hand body installation and elimination,
    rotating rear latch mechanism gets rid of body posts and clips
Suspension: Recorded high-strength steel pins, double large
    connections, adjustable roll center
Shocks: GTX aluminum bodied, oil-filled, integrated wiper seal keeps
    shafts clean minimizing seal wear
Shock Towers: Composite plastic construction, also function as bring
    handles and level supports when car is put upside down
Tires: Aggressive all-terrain tread 8 x 4 x 4"
    foam inserts
Wheels: 4.3x5.7 inches (110x145mm), 17mm hexes
Steering: Bellcrank
Bumpers: Front and rear composite plastic with effect cushions
    behind each bumper to soften blows and add to sturdiness
Ball Bearings: Sealed, full contact
Radio Box: Water resistant

INCLUDES:
RTR X-Maxx Truck with Brushless Motor, Radio, ESC, Painted Body,
    Quick Start Guide and Maintenance Tools

NEEDS:
Batteries: Two THREE LiPo 5000mAh or greater
Battery Charger: Compatible with chosen LiPo batteries
AA Cells: For for transmitter
LiPo Charging Bag

SPECIFICATIONS:
Car;
Length: 29.84" (758mm)
Front Track: 22.26" (540mm)
Rear Track: 20.66" (525mm) range from outer edges of wheels
    measured side-to-side
Ground Clearance: 4" (102mm)
Weight: 19.1pounds (8.66kg)
Ride Height: 13.79" (350mm)
Total Drive Ratio: 8.24
Wheelbase: 18.92" (480mm)
Shock Length: 7.4" (187mm)
Battery Tray Dimensions: 7.7 x 2 x 1.7" (197mm x 51.5mm x 44mm)
    Body;
Length:
Width:
Height:

COMMENTS:
Offered in the following colors;
    Blue, TRAD75BB
    Red, TRAD75RR

For Replacement Ball Bearings usage:
    Qty. Size Area Qty. Bearing Set