Traxxas 5000Mah 11.1V 3S 25C Ml Lipo

This is the Traxxas Power Cell 11.1V 5000mAh 25C THREE LiPo Battery.

FEATURES:
Semi rigid building and construction does not require a hard case and gets rid of
    wire harness ports that can loosen and fail
Engineered particularly to fit Traxxas designs
New high present port with gold-plated copper terminals and
    integrated balance port
iD Car Battery Recognition enables Traxxas iD equipped chargers to
    instantly set and optimize charge settings for particular battery
MAXX cable high-efficiency 12 gauge silicone jacketed wire

SUCHES AS:
Traxxas Power Cell 11.1V 5000mAh 25C LiPo THREE Battery with High
    Existing Connector and Integrated Balance Plug

REQUIRES:
LiPo compatible battery charger such as the Traxxas EZ-Peak Plus, TRAP2970
LiPo charging bag

SPECIFICATIONS:
Setup: 3S1P
Continuous Discharge: 25C (125A)
Max Burst Rate: 50C (250A)
Watt Hours: 55.5
Charge Rate: 1C (5A)
Max Charge Rate: 2C (10A)
Dimensions: 6.1 x 1.02 x 1.7" (155 x 26 x 44mm)
Weight: 13.3oz (376g)

COMMENTS:
ALWAYS use a LiPo-approved Battery charger
ALWAYS use a LiPo Cell Balancer
NEVER Charge over 4.20V per cell
NEVER Charge at currents higher than 1C
NEVER EVER Trickle Charge
NEVER allow to Release below 2.5V per cell
NEVER take apart or customize pack wiring in any way or leak cells
NEVER place on combustible products or leave ignored throughout
    charging
ALWAYS Charge in a fire-resistant place
ALWAYS set battery charger's output volts to match battery volts
ALWAYS shut out of reach of children

Below is an additional thing that praises the thing being talked about.

Ez-Peak Plus Plus 100 Watt Nimh/Lipo Dual Charger W/ Id System

This is the Air Conditioning Powered Traxxas EZ-Peak 100W Double Battery Battery charger
with iD Car Battery Identification.

FEATURES:
Charges 2S and THREE LiPo batteries
5-8 cell NiMH batteries
Traxxas's iD technology instantly sets up and optimizes charge
    settings for Traxxas iD equipped batteries
Charges 2 batteries simultaneously at approximately 50W (4 amps) each, or
    charges single battery at 100W (8 amp) output in High-Output
    mode
Charges a NiMH and LiPo at the exact same time
Advanced Mode for full manual control of battery charger settings
Progress bar and audible notifies
Storage Mode prepares LiPo batteries for prolonged storage
One Month limited service warranty through Traxxas beginning at date of
    purchase

SUCHES AS:
Traxxas EZ-Peak 100W Double Battery Battery charger with Air Conditioning Power Cord,
    Directions, Cooling Fan

SPECIFICATIONS:
Input Power: 100-240V/50-60Hz
Output: 100W max
Charge Current: 1-4A (double mode), 5-8A (high output mode)
Discharge Current Variety: 500mA
Existing Drain for Balance Ports: 500mA
Weight: 20.3oz (575g)
Dimensions: 7 x 5.4 x 2.2" (176 x 138 x 57mm)

This thing is often acquired with the above mentioned thing.



This is the 2.4GHz Radio Controlled, Brushless Electric Powered,
Ready to Run Traxxas X-Maxx.

Ingenious New Features Include;

**Unique Self-Righting Action, if automobile rolls upside down**
**just push a button on the transmitter and most of the times**
**the X-Maxx will turn upright onto its wheels.**

**One handed body install and removal system**
**gets rid of body posts and pins.**

**Battery Retention System gets rid of body clips or hook and loop straps**

**Shock towers likewise act as bring manages and level supports**
    **when automobile is put upside down for maintenance.**

**Additional Technical Details Will Be Included When It Appears.**

FUNCTIONS:
Traxxas Stability Management (TSM): Superior tuning algorithms run on
    high-speed electronic parts to control wheel spin and steering
    direction on loose dirt, concrete and even ice and snow. TSM can be
    fine tuned or switched off by changing the multi-function knob on
    the TQi transmitter or the slider in the Traxxas Link app
Chassis: Composite nylon tub, modular design supplies easy access
    to important parts, lower front and rear skids and integrated
    nerf bars for front, rear and side impact security
Drive Four wheel shaft drive, high-strength steel CV driveshafts with
    splined wheel hexes that get rid of axle pins, aluminum splined
    center driveshaft
Brushless Motor: Velineon 1600, 4 pole 1600Kv, 5mm shaft, aluminum
    heat sink
Motor Mount: Cradle design gets rid of flexing, keyed pins lock gear
    mesh in location
Radio: 2.4GHz TQi transmitter with 5-ch micro TSM telemetry ready
    receiver, BEC voltage and motor temperature level sensing units installed,
    self righting button, built-in fail safe,
    can be equipped with the TQi Docking Base in addition to the iPhone,
    iPad or iPod touch* to create a visual user interface for the
    automobile Traxxas Link TQi Wireless Module needed (not consisted of)
Guiding Servo: High-torque with aluminum heat sink, double shear
    bearing supported servo horn
Electronic Speed Control: Velineon VXL-6s 6S LiPo compatible
Transmission; Single speed
Differentials: Sealed hardened steel bevel, oil filled, limited slip
Slipper Clutch: Double fan cooled
Battery Retention System: Integrated into chassis leading brace for
    higher rigidness, gets rid of body clips or hook and loop straps,
    adjustable for different batteries
Body: ProGraphix painted and cut
Body Mount System: Quick one-hand body installation and removal,
    rotating rear latch mechanism gets rid of body posts and clips
Suspension: Caught high-strength steel pins, double large
    connections, adjustable roll center
Shocks: GTX aluminum bodied, oil-filled, integrated wiper seal keeps
    shafts clean lowering seal wear
Shock Towers: Composite plastic building and construction, likewise act as bring
    manages and level supports when automobile is put upside down
Tires: Aggressive all-terrain tread 8 x 4 x 4"
    foam inserts
Wheels: 4.3x5.7 inches (110x145mm), 17mm hexes
Steering: Bellcrank
Bumpers: Front and rear composite plastic with impact cushions
    behind each bumper to soften blows and contribute to sturdiness
Ball Bearings: Sealed, full contact
Radio Box: Water resistant

SUCHES AS:
RTR X-Maxx Truck with Brushless Motor, Radio, ESC, Painted Body,
    Quick Start Guide and Maintenance Tools

REQUIRES:
Batteries: 2 THREE LiPo 5000mAh or higher
Battery Battery charger: Compatible with selected LiPo batteries
AA Cells: For for transmitter
LiPo Charging Bag

SPECIFICATIONS:
Vehicle;
Length: 29.84" (758mm)
Front Track: 22.26" (540mm)
Rear Track: 20.66" (525mm) range from external edges of wheels
    determined side-to-side
Ground Clearance: 4" (102mm)
Weight: 19.1lbs (8.66kg)
Trip Height: 13.79" (350mm)
Total Drive Ratio: 8.24
Wheelbase: 18.92" (480mm)
Shock Length: 7.4" (187mm)
Battery Tray Dimensions: 7.7 x 2 x 1.7" (197mm x 51.5mm x 44mm)
    Body;
Length:
Width:
Height:

COMMENTS:
Available in the following colors;
    Blue, TRAD75BB
    Red, TRAD75RR

For Replacement Ball Bearings use:
    Qty. Size Location Qty. Bearing Set