RC Screwz SS Screw Set-TRA E-Revo 2

Specs

Part Type: Hardware

This product praises the above discussed product.

Susp Pin Set Frnt Or Rr Hardend Steel 3 X 20Mm (4) 3 X

SUSP PIN SET FRNT OR RR HARDEND STEEL 3 X 20MM (4) 3 X

This product praises the above discussed product.

Traxxas Revo, T-Maxx 2.5R / 3.3 & E-Maxx 16.8 Axle Carriers & Ov

Traxxas Revo, T-Maxx 2.5R / 3.3 & E-Maxx 16.8 Axle Carriers & Oversized Bearings-Blue

RPM axle providers for the Traxxas Revo, Slayer, T-Maxx 2.5R & 3.3 and newer variations of the E-Maxx have actually been fastidiously upgraded to improve the sturdiness, strength, and reliability of these much-abused parts. Have a look at this shopping list of functions built into each set of RPM providers:

Axle Carriers:

Stock replacement-no adjustments are needed to bolt them in.

Larger bearing tires accept RPM oversized bearings.

Included in each set are 2 15mm bearings and 2 21mm bearings.

The wall density around the pillow-balls has been increased by 40%-eliminating split walls!

More than 20% more product supports the pillow-balls, avoiding them from pulling through.

Redesigned enhancing rib supporting the tie rod mount.

Redesigned boot lock tabs making elimination of the silicone boots easier.

Press-fit bearings in the carrier indicates minimized motion of the axle in the carrier.

Oversized Bearings:

Outer bearings are 6x15x5mm (stock is 6x12x4mm).

Inner bearings are 12x21x5mm (stock is 12x18x4mm).

Broader bearings develop an extra 2mm of contact with the axle for smoother, longer running efficiency.

3mm. bigger bearings have balls a complete 33% bigger than stock!

The load scores of RPM oversized bearings are double that of stock bearings and more than triple the tiredness rating of stock bearings as well!

Pillow-Ball Setscrews:

Two-piece style utilizes aluminum and Delrin for the ultimate in holding power under extreme situations.

Our aluminum setscrews lower motion of the pillow-balls in the carrier.

Our Delrin bushing caps have more than twice the contact area on the pillow-ball, keeping the pillow-balls locked in place at all times.

What's Consisted of: RPM Revo axle providers are offered with 1 left and 1 right axle carrier, 2 external 15mm bearings, 2 inner 21mm bearings, 4 aluminum setscrews, 4 Delrin bushing caps, and comprehensive guidelines to assist install them on your truck. TWO bundles will be needed to complete one automobile (unless used with the RPM True-Track Rear End Conversion, then one package is all that is needed).

Tech Notes: Due to increased product to support the pillow balls from pulling through the carrier, RPM Revo Axle Carriers will not work in combination with 120-LT Long Travel rockers (Traxxas #5356).

Right here is a wonderful product that several others have actually purchased the very same time.

Chassis Brace, Rear For Summit E-Revo

CHASSIS BRACE, BACK FOR SUMMIT E-REVO

Right here is a wonderful product that several others have actually purchased the very same time.

DRIVESHAFT, STEEL CONSTAN

This product is often bought with the above mentioned product.

DRIVESHAFTS, CENTER E-REV