RC Screwz SS Screw Set-TRA E-Revo 2

Specs

Part Type: Hardware

This product compliments the above gone over product.

Susp Pin Set Frnt Or Rr Hardend Steel 3 X 20Mm (4) 3 X

SUSP PIN SET FRNT OR RR HARDEND STEEL 3 X 20MM (4) 3 X

This product compliments the above gone over product.

Traxxas Revo, T-Maxx 2.5R / 3.3 & E-Maxx 16.8 Axle Carriers & Ov

Traxxas Revo, T-Maxx 2.5R / 3.3 & E-Maxx 16.8 Axle Carriers & Oversized Bearings-Blue

RPM axle providers for the Traxxas Revo, Slayer, T-Maxx 2.5R & 3.3 and more recent variations of the E-Maxx have been painstakingly redesigned to enhance the resilience, strength, and reliability of these much-abused parts. Have a look at this shopping list of functions developed into each set of RPM providers:

Axle Carriers:

Stock replacement-no modifications are required to bolt them in.

Larger bearing tires accept RPM extra-large bearings.

Included in each set are two 15mm bearings and two 21mm bearings.

The wall density around the pillow-balls has actually been increased by 40%-eliminating split walls!

More than 20% more product supports the pillow-balls, preventing them from pulling through.

Redesigned strengthening rib supporting the tie rod mount.

Redesigned boot lock tabs making elimination of the silicone boots easier.

Press-fit bearings in the carrier indicates decreased motion of the axle in the carrier.

Oversized Bearings:

Outer bearings are 6x15x5mm (stock is 6x12x4mm).

Inner bearings are 12x21x5mm (stock is 12x18x4mm).

Wider bearings develop an extra 2mm of contact with the axle for smoother, longer running efficiency.

3mm. bigger bearings have balls a complete 33% bigger than stock!

The load scores of RPM extra-large bearings are double that of stock bearings and more than triple the fatigue rating of stock bearings as well!

Pillow-Ball Setscrews:

Two-piece design utilizes aluminum and Delrin for the supreme in holding power under severe situations.

Our aluminum setscrews reduce motion of the pillow-balls in the carrier.

Our Delrin bushing caps have more than twice the contact location on the pillow-ball, keeping the pillow-balls locked in location at all times.

What's Consisted of: RPM Revo axle providers are sold with 1 left and 1 right axle carrier, 2 outer 15mm bearings, 2 inner 21mm bearings, 4 aluminum setscrews, 4 Delrin bushing caps, and in-depth instructions to assist install them on your truck. 2 plans will be required to complete one lorry (unless used with the RPM True-Track Rear End Conversion, then one plan is all that is required).

Tech Notes: Due to increased product to support the pillow balls from pulling through the carrier, RPM Revo Axle Carriers will not operate in combination with 120-LT Long Travel rockers (Traxxas #5356).

Right here is a terrific product that many others have actually purchased the exact same time.

Chassis Brace, Rear For Summit E-Revo

CHASSIS BRACE, REAR FOR TOP E-REVO

Right here is a terrific product that many others have actually purchased the exact same time.

DRIVESHAFT, STEEL CONSTAN

This product is regularly purchased with the above discussed product.

DRIVESHAFTS, CENTER E-REV