RPM Toe-In Gauge

By making it possible to set the toe in precisely and consistantly, RPM's
toe in gauge enables the racer to obtain more foreseeable steering. The toe in
guage is molded from black plastic, and will work on all 1/10 scale vehicles and
trucks (utilizing included standoffs).

Includes: 1 toe in gauge
2 truck standoffs
Total directions

pcd 5/8/94

This thing is frequently acquired with the above stated thing.



This is the DuraTrax Pit Tech Camber Gauge.

FEATURES:
Quickly and precisely determines camber settings in 1° increments from
    10° favorable to 10° negative
Ideal for on-road and off-road vehicles and trucks
Thumb wheel locks assess settings securely for accurate adjusments
Includes suggestions for setting the camber to accomplish maximum cornering
    efficiency on any type of track design or surface area
Constructed of black plastic

CONSISTS OF:
One DuraTrax Pit Tech Camber Gauge

NEEDS:
Adjusting gauge to preferred setting, placing gauge against wheel or
    tire and changing camber linkages until wheel is lined up with the
    gauge on top and bottom

COMMENTS:
Common off-road buggy and truck settings:
    Front: 1-3° negative
    Rear: 0-1° negative
Note: Unfavorable camber avoids the outside edge of the tire from
    rolling under during cornering. Nevertheless, excessive negative camber
    will cause loss of traction under straight-line velocity

This is a superb enhancement to the thing presently being gone over.

Hex Wheel Hubs

This is the Set of Hex Wheel Hubs for the Traxxas T-Maxx 4WD RTR Monster Truck.
These wheel hubs fit on the end of the stub axles.

FEATURES:
Replaces missing or damaged hex wheel hubs
Hubs are made from molded black plastic
Axle pins are steel

CONSISTS OF:
Two Hex Wheel Hubs
Two 2.5x12mm axle pins

NEEDS:
Inserting pins through stub axles (4953) and placing wheel hubs in
    recessed area of axle carriers (4932).