RPM Toe-In Gauge

By making it possible to set the toe in properly and consistantly, RPM's
toe in gauge enables the racer to obtain more predictable steering. The toe in
guage is molded from black plastic, and will deal with all 1/10 scale vehicles and
trucks (utilizing consisted of standoffs).

Consists of: 1 toe in gauge
2 truck standoffs
Complete instructions

pcd 5/8/94

This thing is often purchased with the above discussed thing.



This is the DuraTrax Pit Tech Camber Gauge.

FEATURES:
Quickly and properly determines camber settings in 1° increments from
    10° positive to 10° negative
Suitable for on-road and off-road vehicles and trucks
Thumb wheel locks gauge settings securely for accurate adjusments
Consists of pointers for setting the camber to accomplish optimal cornering
    efficiency on any kind of track design or surface area
Constructed of black plastic

CONSISTS OF:
One DuraTrax Pit Tech Camber Gauge

NEEDS:
Adjusting gauge to desired setting, placing gauge against wheel or
    tire and changing camber linkages until wheel is aligned with the
    gauge on top and bottom

REMARKS:
Normal off-road buggy and truck settings:
    Front: 1-3° negative
    Back: 0-1° negative
Keep in mind: Unfavorable camber avoids the outside edge of the tire from
    rolling under during cornering. However, excessive negative camber
    will cause loss of traction under straight-line acceleration

This is a great enhancement to the thing presently being gone over.

Hex Wheel Hubs

This is the Set of Hex Wheel Hubs for the Traxxas T-Maxx 4WD RTR Monster Truck.
These wheel hubs fit on completion of the stub axles.

FEATURES:
Changes missing out on or harmed hex wheel hubs
Hubs are made of molded black plastic
Axle pins are steel

CONSISTS OF:
2 Hex Wheel Hubs
2 2.5x12mm axle pins

NEEDS:
Placing pins through stub axles (4953) and placing wheel hubs in
    recessed location of axle providers (4932).