RPM Revo True-Track Rear A-Arm Conversion Kit-Blue

This is the RPM True-Track Back A-Arm Conversion in Blue
for all variations of the Traxxas Revo.

FEATURES:
Removes stock rear toe links, securing the rear toe angle at
    1.5° per side for a total rear toe-in angle of 3°
Removes all rear bump guide for much better rear end tracking
    no matter surface
Changes lower pivot ball with a 4mm size hinge pin for continuous
    rear toe angle
Retains stock upper pivot ball to enable camber modifications
Weighs a total of 1-1/8oz (32g) less than stock parts

CONSISTS OF:
2 each Upper and Lower Back A-Arms
2 Axle Carriers
2 4mm Hinge Pins
Four E-Clips
2 3x16mm Shock Mount Screws
2 Aluminum Pivot Ball Set Screws
2 Delrin Pivot Ball Bushing Cups
2 6x15mm Sealed Outer Bearings
2 12x21mm Sealed Inner Bearings
Guideline sheet

REQUIRES:
Removing stock rear parts

REMARKS:
This True-Track system is compatible with the following RPM
    parts;
    RPMC8237 Front Black A-Arms
    RPMC8238 Front Blue A-Arms
    RPMC8222 Black Front Upper and Lower Left A-Arms
    RPMC8585 RPM Axle Carriers/Steering Blocks

Not compatible with the Traxxas #5356 Long Travel Rocker Set.

The below item additionally pairs truly well with the item being discussed.

Front Right A-Arms, For Summit, Revo & E-Revo, Blue

This is a set of RPM Blue Front Upper and Lower Right A-Arms
for the Traxxas Revo.

FEATURES:
Constructed of composite nylon
Angled leading and tracking edges remove dirt build-up
No excessive A-arm endplay for more accurate caster and toe angle
    settings
Big shock rod installing locations for improved rigidity

CONSISTS OF:
One Front Upper Right and one Front Lower Right A-Arm and one 16mm
    shock installing screw

REQUIRES:
Installing on vehicle and attaching shock install rod
Inspecting camber angles with Camber Gauge, RPMC7099

SPECIFICATIONS:
UPPER LOWER
Length: 4.9" (124mm) 5.9" (149mm)
Width: 2.5" (63mm) 2.8" (72mm)

REMARKS:
For Upper and Lower Left A-Arms order RPMC8226.