RPM Front Lower A-Arms For The Associated Mt8, Blue

RPM Front A-arms for the Associated MT8 are created to enhance toughness over stock A-arms. How did they do it? Initially, by increasing the amount of product surrounding the inner hinge pins by 7%, then increasing the width of that thicker size by almost 40%! They then increased the amount of product at the external hinge pins by 28%! They also increased the width there too, by another 9%.

The support beams on RPM A-arms also got beefier. At their thickest, stock a-arms are approximately 1/2" (12.7mm) thick however taper down on both ends. That totals up to a loss of almost 30% of their thickness at the external hinge pins. Not with RPM! Their A-arms are a full 1/2" (12.7mm) over almost their whole length! They only taper them a little at the inner hinge pins (.45" or 11.43mm at their narrowest) to match the optimum size permitted of the inner hinge pin employers. To compensate for that small taper, they utilize four massive support beams instead of two, making RPM MT8 A-arms the most difficult option to equip available!

All RPM A-arms are molded from their almost unbreakable blend of engineering grade nylons for performance you can trust.

Tech Notes: RPM Associated MT8 A-arms are sold in pairs. Their A-arms replace stock Associated #25911.

Product Produced: 10/28/2022