RPM Front Lower A-Arms For The Associated Mt8, Black

RPM Front A-arms for the Associated MT8 are created to enhance sturdiness over stock A-arms. How did they do it? Initially, by increasing the amount of product surrounding the inner hinge pins by 7%, then increasing the width of that thicker size by nearly 40%! They then increased the amount of product at the outer hinge pins by 28%! They also increased the width there too, by another 9%.

The assistance beams on RPM A-arms also got beefier. At their thickest, stock a-arms are approximately 1/2" (12.7mm) thick however taper down on both ends. That totals up to a loss of nearly 30% of their density at the outer hinge pins. Not with RPM! Their A-arms are a complete 1/2" (12.7mm) over nearly their whole length! They only taper them a little at the inner hinge pins (.45" or 11.43mm at their narrowest) to match the maximum size allowed of the inner hinge pin employers. To compensate for that minor taper, they use 4 huge assistance beams instead of two, making RPM MT8 A-arms the hardest option to stock available!

All RPM A-arms are formed from their nearly indestructible blend of engineering grade nylons for performance you can trust.

Tech Notes: RPM Associated MT8 A-arms are offered in sets. Their A-arms change stock Associated #25911.

Product Created: 10/28/2022