RJX Servo Wire Braided Sleeving Wrap Color Blue/White (1m)

Details



Planning to clean up the look of your helicopter, aircraft of RC car & secure your servo lines from chaffing? Servo Line Covering is an easy way to secure your servo wires, including a tidy, aesthetic look to your RC device, and can be set up in a matter of minutes. Select from our interesting line of diverse colors to include a whole new look to your RC machine!

Included In Plan:
(1) 1M (3.28 ft.) Servo Wire Braided Sleeving Wrap
(1) 9 in. Heat Shrink Wrap
How Do I Install Servo Line Covering?

Simply remove your servo(s) from the receiver, measure the length of covering you will need for your servo wire(s), and open one end of the covering and insert the servo terminal inside. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the consisted of heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat weapon to diminish it down around the covering, therefore giving you a flush, tight fit over the previously frayed servo covering. Do the exact same with the end of your servo wire, bewaring to leave the terminal bare so it can easily plug into your receiver. Also, make certain to remember of the servo wire polarity if you cover the full wire – this will guarantee that you will understand exactly what instructions to plug your servo terminal into your receiver.