RJX Servo Wire Braided Sleeving Wrap Color Black 2 (1m)

Seeking to tidy up the look of your helicopter, airplane of RC car & protect your servo lines from chaffing? Servo Line Covering is a simple method to protect your servo wires, including a tidy, visual aim to your RC maker, and can be installed in a matter of minutes. Choose from our amazing line of different colors to include an entire makeover to your RC machine!

Included In Package:
(1) 1M (3.28 ft.) Servo Wire Braided Sleeving Wrap
(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?
Simply remove your servo(s) from the receiver, measure the length of covering you will require for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the included heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat gun to diminish it down around the covering, thus offering you a flush, tight fit over the previously torn servo covering. Do the exact same with completion of your servo wire, taking care to leave the terminal bare so it can quickly plug into your receiver. Likewise, make sure to keep in mind of the servo wire polarity if you cover the full wire – this will make sure that you will understand what instructions to plug your servo terminal into your receiver.