RJX Servo Wire Braided Sleeving Wrap Color Black 2 (1m)

Seeking to clean up the appearance of your helicopter, aircraft of RC car & protect your servo lines from chaffing? Servo Line Covering is an easy way to protect your servo wires, adding a clean, aesthetic seek to your RC maker, and can be installed in a matter of minutes. Select from our exciting line of diverse colors to include an entire make over to your RC machine!

Included In Plan:
(1) 1M (3.28 ft.) Servo Wire Braided Sleeving Wrap
(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?
Simply get rid of your servo(s) from the receiver, measure the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the included heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat weapon to diminish it down around the covering, hence providing you a flush, tight fit over the previously frayed servo covering. Do the same with the end of your servo wire, being careful to leave the terminal bare so it can quickly plug into your receiver. Also, make sure to take note of the servo wire polarity if you cover the complete wire – this will guarantee that you will understand what direction to plug your servo terminal into your receiver.