RJX Servo Wire Braided Sleeving Wrap Color Black 2 (1m)

Seeking to clean up the look of your helicopter, plane of RC car & secure your servo lines from chaffing? Servo Line Covering is a simple method to secure your servo wires, including a tidy, visual want to your RC device, and can be installed in a matter of minutes. Pick from our exciting line of diverse colors to include a whole makeover to your RC machine!

Included In Plan:
(1) 1M (3.28 ft.) Servo Wire Braided Sleeving Wrap
(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?
Simply get rid of your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the consisted of heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat gun to diminish it down around the covering, hence giving you a flush, tight fit over the previously torn servo covering. Do the exact same with completion of your servo wire, being careful to leave the terminal bare so it can quickly plug into your receiver. Likewise, make sure to take note of the servo wire polarity if you cover the full wire – this will make sure that you will know what instructions to plug your servo terminal into your receiver.