RJX Servo line Color Blue/Black (1m)

Wanting to tidy up the look of your helicopter, aircraft of RC vehicle & safeguard your servo lines from chaffing? Servo Line Covering is a simple method to safeguard your servo wires, adding a clean, visual aim to your RC maker, and can be set up in a matter of minutes. Pick from our interesting line of diverse colors to include an entire makeover to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the included heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, thus offering you a flush, tight fit over the formerly frayed servo covering. Do the very same with the end of your servo wire, taking care to leave the terminal bare so it can quickly connected into your receiver. Likewise, be sure to bear in mind of the servo wire polarity if you cover the complete wire – this will guarantee that you will know exactly what instructions to plug your servo terminal into your receiver.

Below is a wonderful thing that lots of others have actually bought at the same time.

Servo line Color Black and Red

Wanting to tidy up the look of your helicopter, aircraft of RC vehicle & safeguard your servo lines from chaffing? Servo Line Covering is a simple method to safeguard your servo wires, adding a clean, visual aim to your RC maker, and can be set up in a matter of minutes. Pick from our interesting line of diverse colors to include an entire makeover to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the included heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, thus offering you a flush, tight fit over the formerly frayed servo covering. Do the very same with the end of your servo wire, taking care to leave the terminal bare so it can quickly connected into your receiver. Likewise, be sure to bear in mind of the servo wire polarity if you cover the complete wire – this will guarantee that you will know exactly what instructions to plug your servo terminal into your receiver.