RJX Servo line Color Blue/Black (1m)

Aiming to tidy up the look of your helicopter, plane of RC car & secure your servo lines from chaffing? Servo Line Covering is an easy method to secure your servo wires, adding a clean, aesthetic look to your RC maker, and can be installed in a matter of minutes. Select from our amazing line of different colors to include a whole new look to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and place the servo terminal inside. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the suched as heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat gun to diminish it down around the covering, thus offering you a flush, tight fit over the previously frayed servo covering. Do the exact same with the end of your servo wire, taking care to leave the terminal bare so it can quickly plug into your receiver. Also, make certain to bear in mind of the servo wire polarity if you cover the complete wire – this will guarantee that you will know exactly what instructions to plug your servo terminal into your receiver.

Below is a fantastic thing that many others have actually bought at the very same time.

Servo line Color Black and Red

Aiming to tidy up the look of your helicopter, plane of RC car & secure your servo lines from chaffing? Servo Line Covering is an easy method to secure your servo wires, adding a clean, aesthetic look to your RC maker, and can be installed in a matter of minutes. Select from our amazing line of different colors to include a whole new look to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and place the servo terminal inside. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the suched as heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat gun to diminish it down around the covering, thus offering you a flush, tight fit over the previously frayed servo covering. Do the exact same with the end of your servo wire, taking care to leave the terminal bare so it can quickly plug into your receiver. Also, make certain to bear in mind of the servo wire polarity if you cover the complete wire – this will guarantee that you will know exactly what instructions to plug your servo terminal into your receiver.