RJX Servo line Color Black & Green

Aiming to clean up the appearance of your helicopter, airplane of RC vehicle & safeguard your servo lines from chaffing? Servo Line Covering is a simple way to safeguard your servo wires, including a clean, visual want to your RC device, and can be installed in a matter of minutes. Pick from our amazing line of varied colors to add a whole new look to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply eliminate your servo(s) from the receiver, measure the length of covering you will need for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the suched as heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat weapon to diminish it down around the covering, thus providing you a flush, tight fit over the previously frayed servo covering. Do the exact same with the end of your servo wire, bewaring to leave the terminal bare so it can quickly connected into your receiver. Likewise, make certain to take note of the servo wire polarity if you cover the full wire – this will ensure that you will understand what instructions to plug your servo terminal into your receiver.

This is a fantastic addition to the thing currently being discussed.

Servo line Color Black and Red

Aiming to clean up the appearance of your helicopter, airplane of RC vehicle & safeguard your servo lines from chaffing? Servo Line Covering is a simple way to safeguard your servo wires, including a clean, visual want to your RC device, and can be installed in a matter of minutes. Pick from our amazing line of varied colors to add a whole new look to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply eliminate your servo(s) from the receiver, measure the length of covering you will need for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the suched as heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat weapon to diminish it down around the covering, thus providing you a flush, tight fit over the previously frayed servo covering. Do the exact same with the end of your servo wire, bewaring to leave the terminal bare so it can quickly connected into your receiver. Likewise, make certain to take note of the servo wire polarity if you cover the full wire – this will ensure that you will understand what instructions to plug your servo terminal into your receiver.