RJX Servo line Color Black & Green

Looking to clean up the look of your helicopter, plane of RC vehicle & secure your servo lines from chaffing? Servo Line Covering is a simple method to secure your servo wires, including a clean, aesthetic want to your RC maker, and can be set up in a matter of minutes. Select from our interesting line of diverse colors to add a whole new look to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply remove your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and place the servo terminal inside. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the consisted of heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat weapon to shrink it down around the covering, hence offering you a flush, tight fit over the formerly frayed servo covering. Do the very same with the end of your servo wire, being careful to leave the terminal bare so it can quickly plug into your receiver. Also, make sure to take note of the servo wire polarity if you cover the full wire – this will make sure that you will understand what direction to plug your servo terminal into your receiver.

This is a great addition to the product currently being reviewed.

Servo line Color Black and Red

Looking to clean up the look of your helicopter, plane of RC vehicle & secure your servo lines from chaffing? Servo Line Covering is a simple method to secure your servo wires, including a clean, aesthetic want to your RC maker, and can be set up in a matter of minutes. Select from our interesting line of diverse colors to add a whole new look to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply remove your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and place the servo terminal inside. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the consisted of heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat weapon to shrink it down around the covering, hence offering you a flush, tight fit over the formerly frayed servo covering. Do the very same with the end of your servo wire, being careful to leave the terminal bare so it can quickly plug into your receiver. Also, make sure to take note of the servo wire polarity if you cover the full wire – this will make sure that you will understand what direction to plug your servo terminal into your receiver.