RJX Servo line Color Black and Red

Aiming to tidy up the look of your helicopter, plane of RC automobile & safeguard your servo lines from chaffing? Servo Line Covering is a simple method to safeguard your servo wires, including a clean, visual planning to your RC machine, and can be installed in a matter of minutes. Pick from our interesting line of varied colors to add a whole make over to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply remove your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the included heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, hence offering you a flush, tight fit over the formerly frayed servo covering. Do the very same with the end of your servo wire, taking care to leave the terminal bare so it can easily connected into your receiver. Also, be sure to keep in mind of the servo wire polarity if you cover the complete wire - this will guarantee that you will know exactly what instructions to plug your servo terminal into your receiver.

The listed below product additionally pairs truly well with the product being discussed.

Servo line Color Black & Green

Aiming to tidy up the look of your helicopter, plane of RC automobile & safeguard your servo lines from chaffing? Servo Line Covering is a simple method to safeguard your servo wires, including a clean, visual planning to your RC machine, and can be installed in a matter of minutes. Pick from our interesting line of varied colors to add a whole make over to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply remove your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the included heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, hence offering you a flush, tight fit over the formerly frayed servo covering. Do the very same with the end of your servo wire, taking care to leave the terminal bare so it can easily connected into your receiver. Also, be sure to keep in mind of the servo wire polarity if you cover the complete wire – this will guarantee that you will know exactly what instructions to plug your servo terminal into your receiver.